Sunbeam SB8100, SB8300 Operating Instructions

Operating Instructions for your
ironing board

Opening

Support the ironing board in the vertical
position and lift the release lever. Allow the
top leg to drop to the floor while lowering the
board until horizontal.

Adjusting the height

To increase the height of the board, lift the
release lever slightly and pull the board
upward to the desired height setting. To lower
the height, lift the release lever slightly and
gently push downwards on the board until the
desired height setting is reached.

Closing

Ensure that the iron rest is stowed under the
board before closing. To close, raise the rear
of the board (nearest the iron rest) while
lifting the release lever, allowing the rear legs
to rise and the to board swing into the
vertical position.

Using the retractable iron rest

To use the iron rest, slide it out from
underneath the board so that the rest is fully
extended. When you have finished ironing,
push the iron rest firmly back into position
underneath the board before storing.

Caring for the cover

The cotton cover has been treated with

®

Teflon

Fabric Protector from DuPont. Water
rolls off and stains just wipe away. Teflon
provides maximum water and stain
repellency, but still allows the fabric to
breathe. A heat treatment (warm ironing or
tumble drying) will optimize the performance
of Teflon
cycle. Line or tumble dry. Do not dry clean.
To keep the cover’s shape, fit to the board
while still damp and iron dry.

®

. Warm machine wash on a gentle

®

Fitting the cover

Pull tightly on the drawstring to tighten the
cover. Press the toggle and slide it towards
the board to tighten. Release to lock in
position.

1

5 Year Replacement Guarantee

We are so confident of the quality of our
metal ironing board frame should it develop
any malfunction within five years of purchase
(12 months commercial use), due to faulty
materials or manufacture, we will replace it
for you free of charge.

Should you experience any difficulties with
your metal ironing board frame, please
contact our customer service line for advice
on 1300 881 861 in Australia, or 0800
786 232 in New Zealand. Alternatively, you
can send a written claim to Sunbeam at the
address listed below. Upon receipt of your
claim, Sunbeam will seek to resolve your
difficulties or, if the metal ironing board
frame is defective, advise you on how to
obtain a replacement of refund.

Your Sunbeam 5 Year Replacement
Guarantee obviously does not cover misuse
or negligent handling and normal wear and
tear. Similarly, your 5 Year Replacement
Guarantee does not cover freight or any other
costs incurred in making a claim. Please
retain your receipt as proof of purchase.

The benefits given to you by this guarantee
are in addition to your other rights and
remedies under any laws which relate to the
product.

Our goods come with guarantees that
cannot be excluded under the Australian
Consumer Law and under the New Zealand
Consumer Guarantees Act. In Australia you
are entitled to a replacement or refund for a
major failure and for compensation for any
other reasonably foreseeable loss or damage.
You are also entitled to have the goods
repaired or replaced if the goods fail to be
of acceptable quality and the failure does
amount to a major failure.

Should your metal ironing board frame
require repair or service after the guarantee
period, contact your nearest Sunbeam
service centre.

For a complete list of Sunbeam’s authorised
service centres visit our website or call:

Australia

www.sunbeam.com.au

1300 881 861

Units 5 & 6, 13 Lord Street
Botany NSW 2019 Australia

New Zealand

www.sunbeam.co.nz

0800 786 232

26 Vestey Drive, Mt Wellington
Auckland, New Zealand

2