CURVE BREAKFAST SET
2 SLICE TOASTER AND
1.7L KETTLE
User Guide
PUP2000
PUP2000_19EM1 (ANZ).indd 1 9/24/19 10:28
Contents
Sunbeam’s Safety Precautions
Sunbeam’s Safety Precautions 1
Features of your Curve Toaster 2
Using your Curve Toaster 3
Toaster Functions 3
Toasting Tips 4
Care and Cleaning 4
Features of your Curve Kettle 5
Using your Curve Kettle 6
Sunbeam’s 3-Way Safety System 7
Care and Cleaning 8
SAFETY PRECAUTIONS FOR YOUR SUNBEAM
TOASTER.
• Do not place any objects such as toast, bread or
similar on top of your toaster when in use.
• Operate the toaster on a flat level surface.
• The bread may burn, therefore do not use the
toaster near or below combustible material, such
as curtains.
• Do not leave your toaster unattended when in
use.
Sunbeam is very safety conscious when designing
and manufacturing consumer products, but it is
essential that the product user also exercise care
when using an electrical appliance. Listed below are
precautions which are essential for the safe use of
an electrical appliance:
• Read carefully and save all the instructions
provided with an appliance.
• Always turn the power off at the power outlet
before you insert or remove a plug. Remove by
grasping the plug - do not pull on the cord.
• Turn the power off and remove the plug when the
appliance is not in use and before cleaning.
• Do not use your appliance with an extension cord
unless this cord has been checked and tested by
a qualified technician or service person.
• Always use your appliance from a power outlet of
the voltage (A.C. only) marked on the appliance.
• This appliance is not intended for use by persons
(including children) with reduced physical,
sensory or mental capabilities, or lack of
experience and knowledge, unless they have been
given supervision or instruction concerning use
of the appliance by a person responsible for their
safety.
• Children should be supervised to ensure that they
do not play with the appliance.
• The temperature of accessible surfaces may be
high when the appliance is operating.
• Never leave an appliance unattended while in use.
• Clean crumb tray regularly.
• Do not allow crumbs to accumulate in the crumb
tray.
• Do not toast stale bread, rice crackers or similar
on a high setting as they may catch fire.
• WARNING: Never attempt to extract jammed
toast, crumpets or muffins with a knife or
any other metal object, as contact with a live
element may cause electrocution.
• Do not use an appliance for any purpose other
than its intended use.
• Do not place an appliance on or near a hot gas
flame, electric element or on a heated oven.
• Do not place on top of any other appliance.
• Do not let the power cord of an appliance hang
over the edge of a table or bench top or touch
any hot surface.
• Do not operate any electrical appliance with a
damaged cord or after the appliance has been
damaged in any manner. If damage is suspected,
return the appliance to the nearest Sunbeam
Appointed Service Centre for examination, repair
or adjustment.
• For additional protection, Sunbeam recommend
the use of a residual current device (RCD)
with a tripping current not exceeding 30mA in
the electrical circuit supplying power to your
appliances.
• Do not immerse the appliance in water or any
other liquid unless recommended.
• Appliances are not intended to be operated by
means of an external timer or separate remote
control system.
• This appliance is intended to be used in
household and similar applications such as: staff
kitchen areas in shops, offices and other working
environments; farm houses; by clients in hotels,
motels and other residential type environments;
bed and breakfast type environments.
If you have any concerns regarding the performance and use of your appliance,
please visit www.sunbeam.com.au or contact the Sunbeam Consumer Service Line.
Ensure the above safety precautions are understood.
1
PUP2000_19EM1 (ANZ).indd 2-1 9/24/19 10:28
Features of your Curve Toaster
Using your Curve Toaster
7
1
2
3
5
6
4
Plug the toaster into a 230-240 volt AC
power outlet and switch the power on.
Toasting Bread
1. Position the bread into the bread slot.
2. Select the desired browning setting using
the Browning Control.
Note: If toasting 1 slice it is recommended
that you use a lower browning setting to
achieve your required result and to prevent
burning.
Important: Do not toast stale bread, rice
crackers or similar on a high setting as there
is a chance that they may catch fire.
3. Push the Toasting Lever down to
commence the toasting cycle.
4. When the desired browning is achieved,
the toaster will automatically stop toasting
and pop the toast up.
Toaster Functions
5. If you need to remove the toast before the
cycle is complete, press the Cancel button
on the left, top position of the toaster next
to the toasting lever. The Cancel button
will immediately interrupt the toasting
cycle and pop the toast up.
Hot Surfaces
Do Not Touch
This symbol indicates, temperature of
accessible surfaces may be high when the
appliance is operating and for some time
after use.
Cancel button
The Cancel button immediately stops any of
1. Self-centring bread slots
2. Toasting lever
3. Defrost button
4. Browning control dial
2 3
PUP2000_19EM1 (ANZ).indd 2-3 9/24/19 10:28
5. Reheat button
6. Cancel
7. Removable crumb tray
the toasting cycles. As a consequence of this,
the toast will pop up.
Reheat button
The Reheat button can be selected after the
toasting cycle has finished. Simply select the
reheat button and press the toasting lever
down to start the reheat cycle.
Defrost Feature
The defrost feature can be used to toast your
frozen bread. The colour of your toast will
brown according to the toasting setting you
have chosen. This feature is activated by
pressing the defrost button on at any time
during the toasting cycle.
Toasting Tips
Features of your Curve Kettle
• If your bread jams in the toaster, switch
power off, remove the plug from the power
outlet and ease the bread out of the
toaster.
• Ensure muffins or bagels are cut into even
halves and fit freely into the bread slot. Do
not force them into the toaster.
• If toasting 1 slice it is recommended that
you use a lower toaster setting to achieve
your required result and to prevent burning.
Care and Cleaning
Always turn the power OFF and remove the
plug from the power outlet after use and
before cleaning your toaster.
To clean the exterior
Wipe exterior with a slightly dampened cloth
and polish with a soft dry cloth.
Do not use metal scourers or abrasives as this
may scratch the exterior surface.
Removable Crumb Tray
To remove the crumbs, simply pull tray out,
empty and place it back in the toaster.
Important: Clean the crumb tray regularly. Do
not allow crumbs to accumulate, as they may
cause a potential fire hazard.
WARNING: Never attempt to extract jammed
toast, muffins, bagels or crumpets with a knife
or any other metal object, as contact with the
live element may cause electrocution.
To clean the toaster interior
Clean inside the toaster regularly. To do
this, unplug the appliance, turn it upside
down over the sink and gently shake all the
crumbs out.
1
1. Filter (behind spout)
2. Water level window
3. On/off switch
2
3
5
4
4. 360˚ rotational power base with
cord storage
5. Easy clean, fast boil concealed
element
4 5
PUP2000_19EM1 (ANZ).indd 4-5 9/24/19 10:28
Using your Curve Kettle
Sunbeam’s 3-Way Safety System
Before using your kettle.
It is recommended that you clean your kettle
before use by filling the kettle with water,
up to the maximum level indicator, boil and
discard.
Using your kettle.
1. To fill the kettle, remove it from the power
base and lift the lid. Alternatively, the
kettle may be filled through the pouring
spout.
2. Fill the kettle with the desired amount of
water. Always fill the kettle between the
minimum and maximum marks. Too little
water will result in the kettle switching off
before the water has boiled.
NOTE: Do not fill the kettle over the maximum
level, as water may spill out of the spout
when boiling.
3. Push the lid closed firmly until it locks into
position.
4. Place the kettle on the power base and
connect the plug into a 230-240v power
outlet. Turn the power ON.
5. Press the ON/OFF button downwards at the
base of the kettle. The kettle will switch off
automatically once the water has boiled.
NOTE: Ensure that the ON/OFF switch is clear
of obstructions and the lid is firmly closed.
The kettle will not turn off if the ON/OFF
switch is constrained or if the lid is left open.
Do not remove the kettle from the power base
while water is heating.
6. Lift the kettle from the power base and
pour the water.
NOTE: Use caution when pouring the water
from your kettle, as boiling water will scald.
7. The kettle may be stored on the power
base while not in use. The kettle will not
re-boil until the ON/OFF switch is pressed
downward.
NOTE: Ensure the power is turned off at the
power outlet when the kettle is not in use.
Should you accidentally allow the kettle to
operate without water, boil-dry protection will
automatically switch it off. If this occurs,
allow the kettle to cool before filling with
cold water and re-boiling.
Cord Storage Facility.
Excess cord can be stored by winding the
cord around the storage facility underneath
the power base.
Our 3-Way Safety System ensures that your
kettle will:
1. Automatically switch off after boiling.
For convenience, safety and energy
efficiency, your Sunbeam kettle will
automatically switch off after boiling.
2. Cut-out for boil-dry protection.
If the kettle is operated without water, it
will automatically cut-out, preventing any
damage to the element.
If this occurs, allow the kettle to cool
before filling with cold water and
re-boiling.
3. Shut-down in case of overheating.
In the event of overheating, the kettle will
automatically shut down to prevent further
damage. Should this occur, take your kettle
to a Sunbeam Service Centre or Appointed
Service Agent.
6 7
PUP2000_19EM1 (ANZ).indd 6-7 9/24/19 10:28
Care and Cleaning
Always disconnect the kettle from the power
outlet before cleaning.
Never immerse the kettle switch area, cord
or power base in water, or allow moisture to
come into contact with these parts.
Descale Your Kettle Regularly.
Mineral deposits in tap water solidify when
the water is heated; lime scale may be white,
coloured, even rusty-looking and is normally
visible but phosphate scale isn’t generally
visible although may cause the water to
appear cloudy when heated. This may cause
the interior of the water gauge to discolour,
trigger the boil-dry cut-out mechanism or
even reduce the kettle’s life.
Even in soft water areas it is important
to descale your kettle regularly to help
maintains its lifecycle.
NOTE: Failure to descale products regularly
can be deemed as negligent handling and
any faults caused by mineral build up will
not be covered by the Sunbeam 12 Month
Guarantee.
To remove this build-up, use Sunbeam Liquid
Descaler, a simple to use, non-toxic cleaner
available from Sunbeam Appointed Service
Agents.
Alternatively:
1. Fill the kettle with 1 cup of white vinegar
and the remainder with water and allow to
stand overnight. DO NOT BOIL.
2. Empty the solution from the kettle. Any
stains remaining inside the spout can be
removed by rubbing with a damp cloth.
Fill the kettle with clean water, bring to
boil and then discard the water. Repeat
and the kettle will then be ready to use.
To clean the exterior
The plastic surface may be wiped over with
a damp cloth and polished with a soft dry
cloth.
To prevent damage to the appliance do not
use alkaline cleaning agents when cleaning,
use a soft cloth and a mild detergent.
CAUTION: To prevent damage to the
appliance, do not use alkaline, chemical or
abrasive cleaners. Use a soft cloth and a mild
detergent to protect the exterior surface.
To clean the mesh filter.
Open the lid. Grasp the top of the mesh
filter and pull upwards to remove. Wash in
warm soapy water and dry thoroughly before
replacing in the kettle.
Cleaning the concealed heating element
This kettle features a non-corrosive stainless
steel heating element. Over time, scale may
build up on the concealed element inside the
kettle, causing discolouration that may have
the appearance of rust. Be assured this is not
rust. If this occurs clean with a Scotchbrite
scourer or similar and a suitable abrasive
cleaning cream. Rinse and clean throughly
with tap water before using your kettle again.
8 9
PUP2000_19EM1 (ANZ).indd 8-9 9/24/19 10:28
Need help with your appliance?
Contact our customer service team or visit our
website for information and tips on getting the
most from your appliance.
Australia | visit www.sunbeam.com.au
phone 1300 881 861
mail Units 5 & 6, 13 Lord Street,
Botany NSW 2019 Australia.
New Zealand | visit www.sunbeam.co.nz
phone 0800 786 232
mail Level 6, Building 5, Central
Park, 660–670 Great South
Road, Greenlane, Auckland.
Sunbeam Corporation PTY LTD | ACN 000 006 771
Sunbeam is a registered trade mark.
Sunbeam is a division of Newell Brands.
Made in China to Sunbeam’s specification.
Due to minor changes in design or otherwise,
the product you buy may differ slightly from the one shown here.
Approved by the appropriate electrical regulatory authorities.
©Copyright Sunbeam 2020.
09/19
PUP2000_19EM1 (ANZ)
GCDS-SUN825951-JC
PUP2000_19EM1 (ANZ).indd 10 9/24/19 10:28
Loading...