Sunbeam HD2850 User Manual

Salon Finish

Ionic Hairdryer

INSTRUCTION BOOKLET.

HD2850

PLEASE READ THIS BOOK THOROUGHLY AND RETAIN FOR FUTURE REFERENCE.

HD2850 Inst. 19/12/01 3:29 PM Page 1

1

Sunbeam’s Safety Precautions.

Sunbeam are very safety conscious when designing and
manufacturing consumer products, but it is essential that
the product user also exercise care when using an
electrical appliance. Listed below are precautions which
are essential for the safe use of an electrical appliance:

• Read carefully and save all the instructions provided
with an appliance.

• Always turn the power off at the power outlet before
you remove a plug. Remove by grasping the plug - do
not pull on the cord.

• Turn the power off and remove the plug when the
appliance is not in use and before cleaning.

• Do not use your appliance with an extension cord
unless this cord has been checked and tested by your
electricity supplier or qualified technician.

• Always use your appliance from a power outlet of the
voltage (A.C. only) marked on the underside of the
appliance.

• Close supervision is necessary when your appliance is
being used near children or infirm persons.

• Never leave an appliance unattended while in use.

• Young children or infirm persons should be supervised
to ensure that they do not play with the appliance.

• Do not use an appliance for any purpose other than
its intended use.

• Do not place an appliance on or near a hot gas flame,
electric element or in a heated oven. Do not place on
top of any other appliance.

• Do not let the power cord of an appliance hang over
the edge of a table or bench top or touch any hot
surface.

• Do not immerse in water.

• For safety reasons and to avoid maintenance by
unskilled persons, some appliances are ‘sealed’ using
tamperproof means as specified by S.A.A. (Standards
Association of Australia). Such appliances should
always be returned to the nearest Service Centre for
adjustment or repair if required.

• Do not operate any electrical appliance with a
damaged cord or after the appliance has been
dropped or damaged in any manner; If damage is
suspected, return the appliance to the nearest Service
Centre for examination, repair or adjustment. As a
service to Customers, Service Centres will carry out a
free check on your appliance to ensure it is electrically
safe.

• For additional protection Sunbeam recommend the
use of a residual current device (RCD) with a tripping
current not exceeding 30mA in the electrical circuit
supplying the power outlet in use.

• This hairdryer must not come into contact
with water or any other liquid.

• Always switch off your hairdryer at the
power outlet and remove the plug when not
in use.

• Do not wind the cord around the hairdryer
when not in use.

• Do not use or store your hairdryer near tubs,
basins, baths or other vessels which contain
water.

• When the hairdryer is used in a bathroom,
unplug it after use since the proximity of
water presents a hazard, even when the unit
is switched off.

If you have any concerns regarding the performance and use of your appliance, please ring our Toll
Free number (Australia only) 1800 025 059. New Zealand – contact the Sunbeam Office in Auckland.

Ensure the above safety precautions are understood.

SAFETY PRECAUTIONS FOR ALL ELECTRICAL APPLIANCES

SAFETY PRECAUTIONS FOR YOUR IONIC HAIRDRYER.

HD2850 Inst. 19/12/01 3:29 PM Page 2

Features of your Ionic Hairdryer.

2

Ion Generator.

The built-in ion generator produces a constant
stream of negatively charged ions that condition
the hair as it dries. The ions reduce the size of
water droplets in the hair, thus reducing drying
time and the resulting heat damage. The ions
help to smooth the cuticle layer of the hair
shaft, leaving hair healthier, shinier and more
manageable.

Turbo Boost Button.

Pressing the Turbo boost button temporarily
increases the fan speed to generate greater
airflow. This increased airflow reduces drying
time, and thus reduces the risk of heat damage.

1800 Watt.

Provides fast drying power and high
performance.

Cool Shot Button.

Instantly produces a burst of cool air for setting
your style in place.

Detachable Concentrator.

Ideal for spot drying and controlled styling.

Setting Switch.

2 heat / speed settings for controlled styling or
fast drying.

Hang-Up Loop.

For the convenient and neat storage of your
hairdryer.

salonFINISH

Detachable
Concentrator

Cool Shot

Turbo
Button

Heat/Speed
switch

Hang-up
loop

Dual
Filter

Removable
rear cover

HD2850 Inst. 19/12/01 3:29 PM Page 3

Before using your hairdryer.

Squeeze excess moisture from your hair and
towel dry. Comb hair free of all tangles with a
wide tooth comb.

Using your hairdryer.

1. Insert the plug into a 230-240V power outlet
and turn the power on.

2. Select the desired heat/speed setting - 1 for
controlled styling and finishing, or 2 for all
over drying.

3. Using your fingers or a brush, style your hair
as usual until dry.

4. To set your style, finish with a burst of cool
air from the cool shot. To activate the cool
shot, press the cool shot button and hold for
the desired length of time.

Using the Turbo Boost Button.

Pressing the Turbo Boost button increases the
fan speed to generate more airflow for faster
drying. Do not use the Turbo Boost button for

longer than 3 minutes at a time.

The Ionic feature

The built-in ion generator automatically
produces a constant stream of negative ions
whenever your hairdryer is in use.

4

Using your Ionic Hairdryer.

Care and Cleaning.

Turn your hairdryer off after use. Always turn
your hairdryer off and remove the plug from
the power outlet before cleaning.

Do not immerse your hairdryer in water or any
other liquid.

To clean the exterior of your hairdryer, simply
wipe over with a damp cloth and wipe dry.

To clean the filter.

Detach the rear cover by gripping it at the sides,
and pulling firmly.

Remove any hair and fluff from inside the rear
cover and on the rear of the hairdryer. Replace
the rear cover by pushing it back into position.

Clean the rear cover regularly to ensure the
cleanliness of internal components is maintained
to maximise the long life performance of your
hairdryer.

Do not wind the power cord around the
hairdryer, as this may cause strain and damage
the wiring.

Sunbeam is a registered trademark. Made in China. Due to
minor changes in design or otherwise, the product may
differ from the one shown in this leaflet. Approved by the
appropriate Electrical Regulatory Authorities. Backed by
Sunbeam‘s 2 Year Replacement Guarantee and National
Service Network.

© Copyright. SUNBEAM CORPORATION LIMITED 2002.
(INCORPORATED IN N.S.W.) A.C.N. 000 006 771

For more information or advice on this or any other
Sunbeam appliance, visit www.sunbeam.com.au
or contact the Sunbeam Consumer Service Line.

Australia 1800 025 059
New Zealand [phone].

HD2850 Inst. 19/12/01 3:29 PM Page 4