AutoGrinder II
Automatic coffee grinder
Instruction Booklet
EM0420
Please read these instructions carefully
and retain for future reference.
Sunbeam’s Safety Precautions 1
Features of your Sunbeam AutoGrinder II 2
Handy hints for grinding coffee beans
with the Sunbeam AutoGrinder II 4
Using your Sunbeam AutoGrinder II 5
Care and Cleaning of your
Sunbeam AutoGrinder II 6
Contents
Important instructions – retain for
future use.
1
If you have any concerns regarding the performance and use of your appliance,
please visit www.sunbeam.com.au or contact the Sunbeam Consumer Service Line.
Ensure the above safety precautions are understood.
Sunbeam’s Safety Precautions
SAFETY PRECAUTIONS FOR YOUR
SUNBEAM AUTO GRINDER II.
• Always place the unit on a flat, level surface.
• The grinder cannot operate without the lid in
position.
• Switch off and unplug at power point before
cleaning.
Sunbeam is very safety conscious when
designing and manufacturing consumer products,
but it is essential that the product user also
exercise care when using an electrical appliance.
Listed below are precautions which are essential
for the safe use of an electrical appliance:
• Read carefully and save all the instructions
provided with an appliance.
• Always turn the power off at the power outlet
before you insert or remove a plug. Remove
by grasping the plug - do not pull on the cord.
• Turn the power off and remove the plug
when the appliance is not in use and
before cleaning.
• Do not use your appliance with an extension
cord unless this cord has been checked
and tested by a qualified technician or
service person.
• Always use your appliance from a power
outlet of the voltage (A.C. only) marked
on the appliance.
• This appliance is not intended for use by
persons (including children) with reduced
physical, sensory or mental capabilities, or
lack of experience and knowledge, unless they
have been given supervision or instruction
concerning use of the appliance by a person
responsible for their safety.
• Children should be supervised to ensure that
they do not play with the appliance.
• The temperature of accessible surfaces may be
high when the appliance is operating.
• Never leave an appliance unattended while
in use.
• Do not use an appliance for any purpose
other than its intended use.
• Do not place an appliance on or near a hot gas
flame, electric element or on a heated oven.
• Do not place on top of any other appliance.
• Do not let the power cord of an appliance hang
over the edge of a table or bench top or touch
any hot surface.
• Do not operate any electrical appliance with
a damaged cord or after the appliance has
been damaged in any manner. If damage is
suspected, return the appliance to the nearest
Sunbeam Appointed Service Centre
for examination, repair or adjustment.
• For additional protection, Sunbeam
recommend the use of a residual current
device (RCD) with a tripping current not
exceeding 30mA in the electrical circuit
supplying power to your appliances.
• Do not immerse the appliance in water
or any other liquid unless recommended.
• Appliances are not intended to be operated
by means of an external timer or separate
remote control system.
• This appliance is intended to be used in
household and similar applications such
as: staff kitchen areas in shops, offices and
other working environments; farm houses; by
clients in hotels, motels and other residential
type environments; bed and breakfast type
environments.
2
Features of your AutoGrinder
Transparent cover
For ease of use the cover of the AutoGrinder II
also doubles as a measuring cup and being
transparent the user is able to observe the
coffee beans being ground.
Removable grinding bowl
A convenient removable grinding bowl for easy
grind removal and cleaning.
One touch power button
Easy to operate, simply press the power
button and your work is done, the grinder
will automatically stop when the selected
grind is achieved.
Cleaning brush
For easy cleaning use the small brush to remove
stubborn coffee grinds quickly and with no fuss to
ensure quality, fresh grinding results every time.
3
Grind selector
The AutoGrinder II gives you 5 choices of
grind; coarse for plunger coffee through to
fine for espresso coffee.
Sliding cup selector
Adjustable cup setting from 4 to 15 cups.
Cord storage
Convenient and clever cord storage.
• For a good cup of coffee only grind the
amount you need for immediate use, as
ground coffee quickly loses its flavour and
aroma.
• With the Sunbeam AutoGrinder II coffee
beans can be ground from a range of
coarse to a very fine grind. The required
coffee grind will be determined by the
brewing method used or style of coffee
desired. The different brewing methods
include;
BREWING METHOD GRIND
Espresso Machines Fine grind
Stove top Espresso Medium grind
Drip Filtered Medium grind
Plunger or Percolator Coarse grind
• Do not leave coffee beans or grounds in the
open air, for best flavour always store them
in an airtight container.
• When grinding more than 12 scoops of
coffee beans, pour beans into cover, then
turn the grinder upside down and lock onto
the cover. Be sure to align the arrow on the
lid/cover with the ‘unlock’ graphic on the
rear of the grinder and turn the cover to
the left/lock position.
4
Handy hints for grinding coffee
beans with the Sunbeam
AutoGrinder II
5
Before using your Sunbeam AutoGrinder
II, wipe the grinding bowl and blades
clean with a damp cloth and wash the
transparent cover in warm soapy water. Dry
thoroughly.
Note: Allow to dry completely before using.
1. Place the AutoGrinder on a dry, level
surface.
2. Remove the cover of the AutoGrinder II by
turning it to the right/unlock position, then
lift straight up.
3. Using the measurements on the cover,
fill with the desired amount of coffee
beans and pour into the grinding bowl.
Alternatively scoop the beans directly into
grinding bowl.
4. Replace and lock the cover onto the
AutoGrinder II. Align the arrow on the lid/
cover with the ‘unlock’ graphic, on the rear
of the grinder, and turn the cover to the
left/lock position.
5. Plug the power cord into a 230-240V AC
power outlet and turn the power ‘ON’.
6. Rotate the grind selector to the required
grind setting.
Set the cup selector to the number of cups
to be ground.
7. Press the ‘Grind’ button to commence
grinding and then remove finger. The
Sunbeam AutoGrinder II will stop
automatically when the selected grind
is achieved. To stop the grind cycle at
anytime, push the ‘Grind’ button. When the
‘Grind’ button is pressed again, the grinder
will start from the beginning of the timed
cycle.
Important: Do not remove the cover before
the blades have stopped moving.
Using your Sunbeam AutoGrinder II
6
Using your Sunbeam AutoGrinder II continued
8. Once the blades have stopped rotating
unplug the cord from the power outlet and
remove the cover. Rotate the removable
bowl anti-clockwise to release and lift to
remove. Invert the removable bowl and
gently tap the base to loosen and remove
the freshly ground coffee.
Note: The AutoGrinder II will only operate
when the cover is in the locked position.
Do not immerse the motor base of the
AutoGrinder in water.
Do not place the AutoGrinder in the dishwasher.
1. When you have finished grinding, unplug
your AutoGrinder II from the power outlet.
2. Use the soft cleaning brush to clean
around the blades. Carefully wipe the
grinding bowl with a soft, damp cloth.
Important: Use care around sharp blades.
3. Wash the cover in warm soapy water. Rinse
and dry thoroughly. Wipe the exterior of the
AutoGrinder with a damp cloth.
4. To store the power cord, pull down the
base and wrap the cord around the
AutoGrinder II.
Care and Cleaning
7
Notes
Should you experience any difficulties with your
product during the warranty period, please contact
our customer service line for advice on 1300 881 861
in Australia, or 0800 786 232 in New Zealand.
Alternatively, you can send a written claim to
Sunbeam to:
Australia
Units 5 & 6, 13 Lord Street
Botany NSW 2019 Australia
New Zealand
Level 6, Building 5, Central Park,
660-670 Great South Road,
Greenlane, Auckland
Upon receipt of your claim, Sunbeam will seek to
resolve your difficulties or, if the product is defective,
advise you on how to obtain a replacement or refund.
To assist us in managing warranty claims, we
recommend you register your product as soon as
practicable after purchase by creating a MySunbeam
account on our website and send a copy of your
original receipt to Sunbeam.
In order to make a claim under our warranty, you must
have the original proof of purchase documentation for
the product and present it when requested .
Should your product develop any defect within
12 months of purchase because of faulty materials
or workmanship, we will replace or repair it, at our
discretion, free of charge. A product presented for
repair may be replaced by a refurbished product
of the same type rather than being repaired.
Refurbished parts may be used to repair the product.
Our replacement or repair warranty only applies
where a defect arises as a result of faulty material or
workmanship during the warranty period. Your warranty
does not cover misuse or negligent handling (including
damage caused by failing to use the product in
accordance with this instruction booklet), accidental
damage, or normal wear and tear.
Your warranty does not:
• cover freight or any other costs incurred in making a
claim, consumable items, accessories that by their
nature and limited lifespan require periodic renewal
(such as filters and seals) or any consequential loss
or damage; or
• cover damage caused by:
- power surges, power dips, voltage supply problems,
or use of the product on incorrect voltage;
- servicing or modification of the product other than
by Sunbeam or an authorised Sunbeam service
centre;
- use of the product with other accessories,
attachments, product supplies, parts or devices
that do not conform to Sunbeam specifications; or
- exposure of the product to abnormally corrosive
conditions; or
• extend beyond 3 months if the product is used
in commercial, industrial, educational or rental
applications.
The benefits given to you by our warranty are in addition
to other rights and remedies under law in relation to the
product.
In Australia our goods come with guarantees that cannot
be excluded under the Australian Consumer Law. You are
entitled to a replacement or refund for a major failure
and for compensation for any other foreseeable loss or
damage. You are also entitled to have the goods repaired
or replaced if the goods fail to be of acceptable quality
and the failure does not amount to a major failure.
Our goods also come with guarantees that cannot be
excluded under the New Zealand Consumer Guarantees
Act.
If your warranty claim is not accepted, we will inform
you and if requested to do so by you, repair the
product provided you pay the usual charges for such
repair. You will also be responsible for all freight and
other costs.
Should your product require repair or service after the
warranty period, contact your nearest Sunbeam service
centre. For a complete list of Sunbeam’s service
centres, visit our website or call our customer service
line for advice on 1300 881 861 in Australia,
or 0800 786 232 in New Zealand.
This Sunbeam product is covered by a 12 month replacement or repair
warranty, which is in addition to your rights under the Australian Consumer
Law (if your product was purchased in Australia) or New Zealand Consumer
Guarantees Act (if your product was purchased in New Zealand).
12 Month Warranty
09/13
is a registered trademark.
Need help with your appliance?
Contact our customer service team or visit
our website for information and tips on
getting the most from your appliance.
In Australia
Visit www.sunbeam.com.au
Or call 1300 881 861
In New Zealand
Visit www.sunbeam.co.nz
Or call 0800 786 232
Made in China.
Due to minor changes in design or otherwise,
the product may differ from the one shown in this leaflet.
© Copyright.
Sunbeam Corporation Limited 2013.
ABN 45 000 006 771
Units 5 & 6, 13 Lord Street
Botany NSW 2019 Australia
Level 6, Building 5, Central Park
660-670 Great South Road
Greenlane, Auckland
New Zealand
Sunbeam Corporation is a division of GUD Holdings Ltd.
Loading...