Sunbeam 7623 User Manual
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Digital Blood Pressure Monitor
Model 7623 Instruction Manual
Important Notes
Please read this manual carefully before using this device.
This Blood Pressure Monitor is intended for use by adults only.
Children should not use this monitor unless it is under the supervision
of an adult.
Only a physician is qualified to interpret changes in your blood pressure.
This device is not intended to replace regular medical examinations, It is
recommended that your physician review your procedure for using this
monitor. Never make adjustments to your medicaiton unless it is the advice
of a physician.
Please read these instructions carefully for accurate measurements
PARTS IDENTIFICATION
Air connector
Memory button/Power button
PLEASE READ OVER THE
INSTRUCTIONS CAREFULLY
Page 1
~ ASSEMBLING
YOUR
UNIT
hxdalling Batteries
1. .To
install batteries remove the battery cover and insert the batteries into the
battery compartment as shown. Use only “AA” alkaline batteries.
A. Remove the battery cover from bottom of unit. Insert four “AA” size alkaline
batteries as shown, taking care to observe the proper direction for each battery.
Use of alkaline batteries is recommended.
~
B. Replace battery cover.
~2.
Push the air connector firmly into the air socket on the back of the unit.
~ Important Notes
~
l Replace all four batteries if the low battery symbol appears on the display.
l Remove batteries if storing the unit more than six months without use. Never
~
leave dead batteries in an unit since they may leak and cause damage.
1
Memory data will be cleared when batteries are changed or become exhausted.
Proper Use of the Arm Cuff
,l.
Please relax and remain seated or reclined in a quiet location for 5 to 10
~
minutes prior to taking a measurement.
12.
Remove any clothing on the upper arm so that the cuff can be placed directly on
the skin. Constriction of the upper arm caused by rolling up a shirt sleeve may
cause an inaccurate reading. Avoid this condition by completely removing the
garment causing the constriction.
,3.
Wrap the cuff around the upper arm as shown in the diagram on page 3. The
~
lower edge of the cuff (edge with air hose attached) should be about 1 inch
above the elbow. Position the cuff so that the hose runs along the inside of
the left arm.
Page 2
connector.into
~
Taking Your Blood Pressure
1. Place the cuff on the arm that will be used for the measurement
(preferably the left arm). See previous section on proper cuff placement.
‘2. Remaih seated or in a reclining position during measurement.
~
with the cuff as still as possible and position the cuff at heart level. Movement
during measurement could cause an error, requiring a second measurement.
3. Press the power button. When the.power’button is pressed, all of the display
symbols will appear for one second. When the “0” is displayed, the monitor is
ready for measurement. If the
in it.
Rress
the exhaust valve button until
base unit if not
Left Arm
“A’
mark appears, the cuff has some air trapped
already.attached.
“0”
appears.
Keep the arm
Page 3
Loading...