Sunbeam 6911, 6913 User Manual

MODELS/MODÈLES

MODELOS

Installation, Operation and Cleaning Instructions

6911 & 6913

SELECTA SHOWER™ SHOWERHEAD

READ AND SAVE THESE INSTRUCTIONS

Instructions pour Installation, Emploi et Nettoyage

POMMED E DOUCHE SELECTA SHOWER™

LIRE ET CONSERVER CES INSTRUCTIONS

Instrucciones de Instalacion, Operacion y Limpieza

REGADERA SELECTA SHOWER™

LEA Y CONSERVE ESTAS INSTRUCCIONES

3

Important Safety

InStructIonS

Many household accidents occur in the shower or tub.
t

o reduce the incidence, always follow these safety precautions:

1. Read these instructions completely before installing and using this showerhead. Use
only as directed and with attachments and accessories sold by Sunbeam Products, Inc.

2. Do not direct sprays on sensitive parts of the body such as eyes and ears. Consult
a physician before using on severely swollen or sensitive areas, or using to relieve
unexplained pain.

3. Always install non-skid strips or use non-slip bath mats on slippery surfaces in your
shower or tub to reduce the risk of falling.

4. Always check the water temperature before entering the shower to prevent the possibility
of being scalded.

5. Do not allow water to be directed toward or splash on any electric bulbs or heat lamps,
the glass may shatter

6. Periodically inspect all threaded connections to prevent leakage and the possibility of
damage or personal injury from loose, water-propelled parts.

7. Instruct and supervise children and physically challenged users in the proper use of this
product.

8. Do not use tub and tile or general purpose cleaners. They may cause damage to the
product which may result in personal injury or may damage the product’s finish.

InstallatIon InstructIons

Your Sunbeam showerhead attaches to any standard 1/2” threaded shower.
Tools: 1) Wrench or pliers,

2) Soft Cloth.

1. Remove your old showerhead from the shower arm with a wrench or pliers, turning
counterclockwise. Be careful not to loosen your shower arm.

note: if your existing shower arM has an integral ball joint, it Must

be replace with a standard 1/2” shower arM. this standard
shower arM is available at Most hardware stores.

2. Remove any old sealing material and clean all debris from the threads.

3. Wrap Plumber’s tape evenly clockwise onto the threads. Do not use pipe compound.

2

Wall Mount Models

Rotate back of unit counterclockwise 1/4-turn. Carefully thread swivel ball onto the end of
the shower arm, over the Teflon tape, and hand tighten as firmly as possible.

NOTE: should additional tightening be necessary, cover the

swivel ball with a soft cloth, to prevent Marring and
tighten with pliers

do not turn More than 1/4 turn.

Position your Sunbeam showerhead as desired and tighten back of unit. Slowly turn on
cold water and check for leaks. If leaks occur, wrap a soft cloth around the swivel ball and
re-tighten with pliers. DO NOT OVER TIGHTEN.

Backside

Swivel Ball

operatIng InstructIons

To select a setting, turn the selector tab to the desired position. The selector tab will align
with the red symbol designating which setting you have chosen.

Spray/Massage Bubble
Massage Massage/Bubble
Full Spray Spray Mist
Spray Bubble Mist

care & cleanIng

If you notice a drop in water pressure or skewing of water streams, place unit in a vinegar
solution (1 part vinegar to 3 parts water). Allow to soak overnight. Remount showerhead
and run cold water through it for several minutes.

3

5

5-Year Limited HospitaLitY WarrantY

Sunbeam Products, Inc. doing business as Jarden Consumer Solutions in US and Sunbeam
Corporation (Canada) Limited doing business as Jarden Consumer Solutions in Canada

(collectively “JCS”) warrants that for a period of 5 years from the date of purchase, this
product will be free from defects in material and workmanship. JCS, at its option, will repair or
replace this product or any component of the product found to be defective during the warranty
period. Replacement will be made with a new or remanufactured product or component. If the
product is no longer available, replacement may be made with a similar product of equal or
greater value. This is your exclusive warranty.

This warranty is valid for the original purchaser from the date of initial purchase and is not
transferable. JCS dealers, service centers, or stores selling JCS products do not have the
right to alter, modify or any way change the terms and conditions of this warranty.

This warranty does not cover normal wear of parts or damage resulting from any of the
following: negligent or misuse of the product, use contrary to the operating instructions,
disassembly, repair or alteration by anyone other than JCS or an authorized service center.
Further, the warranty does not cover Acts of God, such as fire, flood, hurricanes and
tornadoes.

JCS shall not be liable for any incidental or consequential damages caused by the breach of
any express, implied or statutory warranty or condition. Except to the extent prohibited by
applicable law, any implied warranty of merchantability or fitness for a particular purpose is
limited in duration to the duration of the above warranty. JCS disclaims all other warranties or
conditions, express, implied statutory or otherwise. Some states, provinces or jurisdictions do
not allow the exclusion or limitation of incidental or consequential damages or limitations on
how long an implied warranty lasts, so the above limitations or exclusion may not apply to you.
This warranty gives you specific legal rights, and you may also have other rights that vary from
state to state or province to province.

This warranty is only applicable to products purchased by members of the hospitality industry
and not to consumer sales.

How To Obtain Warranty Service

Contact your JCS authorized dealer.

www.sunbeamhospitality.com

4