Summit STACKINGRACK User Manual
Assembling Your StackRack Combination
StackRack
A. Use when appliances
B. Use when appliances
This sheet will guide you in assembling the two appliances you have received in
separate cartons, and which will be stacked one on top of the other. You have
received two StackRacks and you will need them both whether the upper
appliance is narrower than the lower or the two appliances have equal widths.
have unequal widths
A. If the upper appliance is narrower than the lower:
1. Remove the vertical plates at the ends of the two StackRacks using a
Phillips head screwdriver. You will not need these plates.
2. Place both StackRacks on top of the lower appliance, one toward the front
and one toward the rear. Compress each StackRack until the ends are
flush with the two sides of the appliance.
3. Center the upper appliance on top of the tw o StackRacks so that the legs
(or rear support plate) are firmly seated on the front and rear StackRacks.
4. Loosen the wing nuts (4 on each StackRack) and remove the paper
shields from the four Velcro pads that are facing the upper appliance.
5. Slide the four L-shaped brackets toward the upper appliance until a firm
contact is made, then tighten the wing nuts. This completes the assembly.
B. If the upper and lower appliances have equal widths:
1. Unscrew the four wing nuts on each StackRack and remove the L-shaped
brackets. You will not need them.
2. Place both StackRacks on top of the lower appliance, one toward the front
and one toward the rear. Do not fully compress the StackRacks at this
time.
3. Remove the paper shields from the four Velcro pads that will be facing the
upper appliance.
4. Center the upper appliance on top of the tw o StackRacks so that the legs
(or rear support plate) are firmly seated on the front and rear StackRacks.
5. Compress each StackRack until the ends are flush with the two sides of
the lower appliance and the Velcro pads make firm contact with the upper
appliance. This completes the assembly.
have the same width
Loading...