•
The more coolant there is in an appliance, the larger the room it should be installed in. In the event
of a leakage, if the appliance is in a small room, there is the danger of combustible gases building
up. For every ounce of coolant at least 325 cubic feet of room space is required. The amount of
coolant in the appliance is stated on the data plate on the back of the appliance. It is hazardous for
anyone other than an Authorized Service Person to carry out servicing or repairs to this appliance.
•
Take serious care when handling, moving, and using the appliance to avoid either damaging the
refrigerant tubing or increasing the risk of a leak.
•
Replacing component parts and servicing shall be done by factory authorized service personnel
so as to minimize the risk of possible ignition due to incorrect parts or improper service.
FOLLOW WARNING CALLOUTS BELOW ONLY WHEN APPLICABLE TO YOUR MODEL
•
Use two or more people to move and install appliance. Failure to do so can result in back or other
injury.
•
To ensure proper ventilation for your appliance, the front of the unit must be completely
unobstructed. Choose a well-ventilated area with temperatures above 60°F (16°C) and below 90°F
(32°C). (Optimum operation occurs within the range 72º to 78ºF, or 23º- 26ºC.) This unit must
be installed in an area protected from the elements, such as wind, rain, water spray or drips.
•
The appliance should not be located next to ovens, grills or other sources of high heat.
•
The appliance must be installed with all electrical, water and drain connections in accordance with state
and local codes. A standard electrical supply (115 V AC only, 60 Hz), properly grounded in accordance
with the National Electrical Code and local codes and ordinances, is required.
•
Do not kink or pinch the power supply cord of the appliance.
•
The size of the fuse (or circuit breaker) should be 15 amperes.
•
It is important that the appliance be leveled in order to work properly. You may need to make
several adjustments to level it.
•
All installations must be in accordance with local plumbing code requirements.
•
Make certain that the pipes are not pinched, kinked or damaged during installation.
•
Check for leaks after connection.
•
Never allow children to operate, play with or crawl inside the appliance.
•
Do not use solvent-based cleaning agents or abrasives on the interior. These cleaners may
damage or discolor the interior.
•
Use this appliance only for its intended purpose as described in this User Manual.
•
Keep fingers out of the “pinch point” areas. Clearances between the door and cabinet are
necessarily small. Be careful closing doors when children are in the area.
•
Do not store explosive substances such as aerosol cans with a flammable propellant in this
appliance.
•
Keep ventilation openings, in the appliance enclosure or in the built-in structure, clear of
obstruction.
•
Do not use mechanical devices or other means to accelerate the defrosting process, other than
those recommended by the manufacturer.
•
Do not damage the refrigerant circuit.
•
Do not use electrical appliances inside the food storage compartments of the appliance, unless
they are of the type recommended by the manufacturer.
Risk of child entrapment!
Child entrapment and suffocation are not problems of the past. Junked or abandoned appliances
are still dangerous, even if they will “just sit in the garage a few days”.
Before discarding your old refrigerator:
✓
Take off the doors
✓
Leave the shelves in place so that children may not easily climb inside.
– SAVE THESE INSTRUCTIONS –