Page 1
8
INSTALLING THE STAINLESS STEEL HANDLES
This appliance includes two stainless steel handles
that are not required to operate the unit. To install the
handles, follow the instruct i ons belo w:
1. Remove the door gasket.
2. Install the handle with the screws provided. (DO NOT
over-tighten as this will cause damage to the
stainless steel door surface.)
3. Replace the door gasket.
FULL OVERLAY PANEL INSTALLATION INSTRUCTION
These models are designed for field-installed ov erlay
panels. The overlay panels cover the stainless steel to
give a built-in appearance . The overlay panel and
appropriate hardware are not included with the unit and
the end user needs to prepare them himself. Please
follow the instructions below for installation:
• Remove any items stored inside the drawers. Press
the left slide release lever down and at the s ame time
lift the correspondi ng right s lide lever up, and pull the
drawer out until it is free of tracks and the cabinet.
(Fig. 1)
• Peel off the gasket and remove the handle by
removing the two screws that attach the handle to the
door.
• Drill the 2 holes shown by using a 3/16” drill bit on the
bottom of drawer door front. (Fig. 2)
• Cut the overlay panels with thickness 3/4” to the
following dimensions:
If reusing the handles that came with the unit, drill
two holes with diameter 3/16” in the overlay panel.
Attach the handle and overlay panel together to the
drawer face using 2 M4x55 screws and through the
upper 2 existing holes inside the door groove. Then
attach the overlay panel to the drawer face using 2
wood screws #10x1.5 (ST4x40) Type AB Phillips and
through the lower 2 existing holes inside the door
groove. (Fig. 3)
• If user-supplied handles will be used, attach the
handles to the overlay panels by using t he flat head
screws and drive the screws flush with the panels.
Then attach the overlay panel to the drawer fac e using the 4 wood screws #10x1.5 (ST4x40) and
through the 4 existing holes inside the door groove.
• Peel back the gaskets, then align the left and right slide channels with the tracks in the cabinet.
Ensuring an even track engagement on both sides, gently push t he drawer into the cabinet until it
stops.
Loading...