
2. THERMOSTAT CONTROL
The temperature of the freezer is automatically controlled
by the thermostat setting. The thermostat is preset at the
factory for normal use.
If you require a colder temperature within the freezer, turn
the thermostat knob to a higher number (clockwise).
If you require a warmer temperature within the freezer,
turn the thermostat knob to a lower number (counter
clockwise).
3. DEFROSTING
For the most efficient operation of the freezer with the
minimum electricity consumption, please keep the freezer
clear of frost. The frost should be removed as often as
possible using a plastic ice scraper. The resulting “snow”
should be removed from the cabinet. This procedure will
allow uninterrupted use of the freezer.
If the layer of frost exceeds ¼ inch, we recommend that
you completely defrost the freezer by following this
procedure:
A. Remove all products from the freezer
B. Open the lid(s) and disconnect the plug.
C. Remove as much frost as possible with a plastic ice
scraper.
D. Dry the interior entirely with soft cloth.
E. Reconnect the plug before placing product back in.
2
CAUTION: DO NOT ATTEMPT TO SCRAPE OR PRY
FROST AWAY WITH SHARP OBJECTS.
4. MAINTENANCE AND CLEANING
It is recommended that the freezer be cleaned occasionally.
Freezer body – Clean with a dry cloth. If there are any
stubborn stains use hot water, if necessary, with a mild
detergent. Rinse well and dry.
Inner walls – Defrost as recommended in the previous page.
Clean with warm water. Do not use corrosive detergents.
5. LONG TERM STORAGE
If the freezer is to be kept idle for extended periods of time
please follow the following procedure:
A. Remove plug from outlet.
B. Defrost and clean the freezer thoroughly.
C.Leave lids in open position to avoid formations of
condensation, mold or odors.
THANK YOU FOR HAVING READ THE
INSTRUCTIONS WHICH WE HOPE YOU WILL
FOLLOW CAREFULLY.
3

Thanks for having chosen one of our products. You have
certainly made a good investment and we are sure that our
appliance will prove this to you. Make sure it operates
under its best conditions by complying with the enclosed
instructions.
FELIX STORCH INC.
GENERAL INSTRUCTIONS
Our appliance has been carefully designed to give the best
possible performance.
1. INSTALLATION
A. Please install the freezer in an area which is level, dry,
well ventilated and away from sunlight and heat
sources such as stoves, heaters, etc.
B. For better ventilation around the back and bottom of
the freezer there should be free clearance of at least 23 inches on all sides.
C. The voltage from the outlet must correspond to that
indicated on the back plate of the freezer. A tolerance
of 10% is acceptable.
D. Let the unit run for several hours before placing any
products in it.
1

SUMMIT APPLIANCE DIVISION®
INSTRUCTION MANUAL FOR MODEL:
FELIX
STORCH, INC.
FCL-44
WARNING! This product may contain chemicals known to the state of California
to cause cancer or birth defects or other reproductive harm. For more information,
visit: www.summitappliance.com/prop65
Chemicals known by the manufacturer to be present in this product in concentrations
her than threshold limits: NONE.
hi
CHEST FREEZER