Summit 84018, 84015, 84016, 84019, 84017 User Manual
Instruction Booklet 2006
Summit ATV Modular Trailer Chassis 84016
Summit ATV Trailer Bed 84017
Summit ATV 40 Gallon Sprayer with Trailer 84018
Summit ATV 400 lb Spreader with Trailer 84019
Summit ATV 400 lb Spreader Stand Alone 84015
!
!
READ ME FIRST!!!
Please read carefully BEFORE using you new Summit ATV Product.
Congratulations! You have purchased the nest commercially available ATV implement on the market today. Summit ATV Products are
designed and built to provide years of trouble-free, successful use. This booklet is provided to you to outline the recommended use, care and
maintenance of your Summit ATV Product.
Warnings and Precautions
FAILURE TO READ, UNDERSTAND AND FOLLOW THESE INSTRUCTIONS MAY LEAD TO SERIOUS INJURY OR DEATH!
•
READ, UNDERSTAND AND OBEY YOUR ATV’S INSTRUCTION / SAFETY MANUAL BEFORE USING THIS PRODUCT! ALWAYS WEAR A HELMET!
•
DO NOT EXCEED A SAFE SPEED FOR THE TERRAIN AND SOIL CONDITIONS ENCOUNTERED! NEVER USE ON STEEP SLOPES! NEVER EXCEED
•
YOUR RIDING CAPABILITIES!
DO NOT EXCEED YOUR ATV’S MAXIMUM RATED TOWING CAPACITY!
•
WEIGHT LIMIT 500 LBS.
•
DO NOT OPERATE IF YOU HAVE BEEN USING DRUGS OR ALCOHOL!
•
SUMMIT’S LINE OF ATV TRAILERS ARE DESIGNED FOR USE WITH AN ATV OR GARDEN TRACTOR ONLY. DO NOT USE WITH A CAR, TRUCK
•
OR ANY OTHER VEHICLE!
SUMMIT’S LINE OF ATV IMPLEMENTS ARE NOT DESIGNED FOR HIGH SPEED TRANSPORT ON PUBLIC ROADS!
•
YOU MUST USE A 2” BALL TO CONNECT THIS TRAILER TO YOUR ATV!
•
DO NOT USE THIS TRAILER FOR HUMAN TRANSPORTATION!
•
CHECK AND RETIGHTEN ALL BOLTS PRIOR TO EACH USE!
•
THOROUGHLY RINSE AFTER USE WITH FERTILIZERS OR OTHER CHEMICALS!
•
LUBRICATE ALL GREASE FITTINGS BEFORE FIRST USE!
•
LUBRICATE ALL MOVING PARTS AFTER EVERY USE!
•
ALWAYS FOLLOW SEED / FERTILIZER MANUFACTURER’S GUIDELINES FOR USE!
•
WEAR SAFETY GLASSES AT ALL TIMES WHEN USING THE SPREADER OR SPRAYER!
•
WARNING! THIS TRAILER TRACKS WIDER THAN YOUR ATV - TAKE CARE WHEN MANEUVERING AROUND TREES OR DOWN TRAILS!
•
www.summitATV.com
Section 1. Trailer Adjustments.
WARNING: ALL SUSPENSION ADJUSTMENTS SHOULD BE
MADE TO BOTH SIDES EQUALLY!
The suspension on this trailer system is adjustable for varying loads
and terrain.
The shocks on this trailer are adjustable. Each shock has a collar in the
middle of the shock just below the spring. Turning the collar counterclockwise increases the stiffness of the spring as shown in Figure 1.
It is recommended that the shocks be stiffened for frequent heavy load
use. Lighter loads require less stiffness.
There are three different shock mounting points allowing for three different placements. The closer the shock comes to perpendicular with
respect to the frame, the stiffer it becomes (See Figure 2). Always
adjust both sides equally.
Section 2. Add On Trailer Attachments.
Figure 1
This trailer system has the ability to accept other Summit ATV add ons.
The trailer has four tie down points as shown in Figure 3.
Part 1. Attaching the Bed (PN 84017)
Step 1. Lay the bed on the trailer frame between the welded on brack-
ets as shown in Figure 4.
Step 2. Using the supplied U-Bolts, attach the bed to the frame as
shown in Figure 5. Run one side of the bolt through the pre-drilled
hole in the frame and around the bed frame (See Figure 6).
Part 2. Attaching the 40 Gallon Sprayer (PN 84018)
Step 1. Set the 40 Gallon Spayer frame on the trailer chassis between
the welded on brackets.
Step 2. Connect the supplied ratchet strap to one of the tie off points
as shown in Figure 7.
Step 3. Run the strap up and over the tank and attach to the other side
as shown in Figure 8.
Step 4. Ratchet and repeat for other side.
Part 3. Attaching the 400lb Spreader (PN 84019)
Step 1. Set the spreader frame on the trailer chassis and slide it to the
rear so that the welded on brackets t over the trailer chassis. (See
Figure 9).
Step 2. Mount the U-Bolt over both the spreader frame and the trailer
chassis. Bolt together using the backing plate as shown in Figure 10.
Figure 4
Figure 7
Section 3. Using the Trailer Bed (PN 84017)
The tailgate is hinged and it is held in place with two 5/16” detent pins.
To open the tailgate, simply pull the detent pins out and swing the gate
down (See Figure 11).
Section 4. Using the 40 Gallon Sprayer (PN 84014 or 84018)
Please refer to the enclosed Fimco Instructions for sprayer use and
parts lists.
Loading...