SUGA SWN24EA-0 User Manual

Suga Electronics Limited

© Suga Electronics Limited. All Rights Reserved.
Information in this document is subject to change without prior notice.

1

IEEE 802.11b/g/n (2T2R) WLAN Half-size

Mini PCIe Module User Manual

Model: SWN24EA-0

Version: 1.0

Date: Nov 24, 2015

Contents

1. FCC & IC Statement ...............................................................................................2

1.1. FCC Caution..................................................................................................2

1.2. FCC Radiation Exposure Statement ...........................................................2

1.3. IC Warning .................................................................................................... 3

2. Hardware Installation .............................................................................................4

2.1. Hardware Installation Procedures ..............................................................4

3. Software Installation................................................................................................5

3.1. STA Linux driver installation ...................................................................... 5

4. Example.....................................................................................................................6

4.1. Router setting.................................................................................................6

4.2. Associate SWN24EA-0 with the router........................................................6

5. Device Labeling ........................................................................................................6

6. Disclaimer .................................................................................................................7

Suga Electronics Limited

© Suga Electronics Limited. All Rights Reserved.
Information in this document is subject to change without prior notice.

2

1. FCC & IC Statement

1.1. FCC Caution

Any Changes or modifications not expressly approved by the party responsible for

compliance could void the user's authority to operate the equipment.

This device complies with part 15 of the FCC Rules. Operation is subject to the

following two conditions:

(1) This device may not cause harmful interference, and

(2) This device must accept any interference received, including interference that may

cause undesired operation.

1.2. FCC Radiation Exposure Statement

IMPORTANT NOTE:

This equipment complies with FCC radiation exposure limits.

This equipment should be

installed and operated with

minimum distance 20cm between the radiator & your b

ody.

This module is intended for OEM integrator. The OEM i ntegrator is still responsible for the FCC
compliance requirement of the end product, which integrates this module
The final end product must be labeled in a visible area with the following” Contains
FCC ID: VZFSWN24EA0

The device supports the highest gain of atenna is 4.0dBi.

Suga Electronics Limited

© Suga Electronics Limited. All Rights Reserved.
Information in this document is subject to change without prior notice.

3

1.3. IC Warning

RSS (Category I Equipment):
This device complies with Industry Canada licence-exempt RSS standard(s).
Operation is subject to the following two conditions:
(1) This device may not cause interference, and
(2) This device must accept any interference, including interference that may cause
undesired operation of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux
appareils radio exempts de licence.
L'exploitation est autorisée aux deux conditions suivantes:
(1) l'appareil nedoit pas produire de brouillage, et
(2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si
le brouillage est susceptible d'en compromettre le fonctionnement.
Under Industry Canada regulations, this radio transmitter may only operate using an
antenna of a type and maximum (or lesser) gain approved for the transmitter by
Industry Canada.

This module is intended for OEM integrator. The OEM integrator is still responsible for the IC
compliance requirement of the end product, which integrates this module
The final end product must be labeled in a visible area with the following” Contains
IC: 10609A-SWN24EA0

This radio transmitter (identify the device by certification number) has been approved by Industry
Canada to operate with the antenna types listed below with the maximum permissible gain indicated.
Antenna types not included in this list, having a gain greater than the maximum gain indicated for that
type, are strictly prohibited for use with this device.

Cetémetteurradio(identificationdel'appareilparnumérodecertification)aétéapprouvépar

IndustrieCanadapourfonctionneraveclestypesd'antenneci‐dessousaveclemaximumdegain

admissibleindiqué.Typesd'antennenoninclusdanscetteliste,ayantungainsupérieuraugain

maximumindiquépourcetype,sontstrictement

interditspouruneutilisationaveccetappareil

The device supports the highest gain of antenna is 4.0dBi.