Sudio FLYG User Manual

User manual

Button behavior

Press 2 sec : Turn on, repair to last device, LED blinking white(0.25

sec on/0.25 sec off)

Press 5 sec : Turn on + pairing mode

Press 5 sec : Turn off

LED behavior

Power on/Playback : Power on, If press 2 sec, to re-pair model, LED

blinking 0.25s on/off. If press 5sec, it's BT pairing mode, LED blinking 0.5s

on/off.

Bluetooth Pairing : Blinking White (0.5 sec on/0.5 sec off)

Charging : Solid Red

Low Battery (< 10%) : Blinking Red (0.25 sec on/0.25 sec off)

Specifications :

Product name:

Model:

Bluetooth version: 5.0

Bluetooth range: 10m

Working time:

Charging time:1h

Battery: 5v 400mAh rechargeable

Charging type: USB-C

Input: DC 5v 0.5A

FCC Requirement

changes or modifications not expressly approved by the party responsible for

compliance could void the user’s authority to operate the equipment.

This device complies with Part 15 of the FCC Rules. Operation is subject to the

following two conditions:

(1) this device may not cause harmful interference, and

(2) this device must accept any interference received, including interference that

may cause undesired operation.

Note: This equipment has been tested and found to comply with the limits for a

Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are

designed to provide reasonable protection against harmful interference in a

residential installation. This equipment generates, uses, and can radiate radio

frequency energy, and if not installed and used in accordance with the instructions,

may cause harmful interference to radio communications. However, there is no

guarantee that interference will not occur in a particular installation. If this

equipment does cause harmful interference to radio or television reception, which

can be determined by turning the equipment off and on, the user is encouraged to

try to correct the interference by one or more of the following measures:

– Reorient or relocate the receiving antenna.

– Increase the separation between the equipment and receiver.

– Connect the equipment into an outlet on a circuit different from that to which the

receiver is connected.

– Consult the dealer or an experienced radio/TV technician for help.