INSTALLATION GUIDE
Induction and Electric Cooktops
Contents
Important Note
Wolf Induction and Electric Cooktops . . . . . . . . . . . . . 3
Cooktop Specifications . . . . . . . . . . . . . . . . . . . . . . . . 4
Cooktop Installation . . . . . . . . . . . . . . . . . . . . . . . . . . 14
Service Information . . . . . . . . . . . . . . . . . . . . . . . . . . . 18
Features and specifications are subject to change at any time
without notice. Visit wolfappliance.com/specs for the most
up-to-date information.
IMPORTANT NOTE: Throughout this guide, dimensions in
parentheses are millimeters unless otherwise specified.
o ensure the safe and efficient use of Wolf equipment,
T
please take note of the following types of highlighted
information throughout this guide:
IMPORTANT NOTE highlights information that is especially
important.
CAUTION signals a situation where minor injury or product
damage may occur if instructions are not followed.
WARNING states a hazard that may cause serious injury or
death if precautions are not followed.
Wolf Induction and Electric Cooktops 3
M
E
L
T
O
F
F
H
I
-
P
O
W
E
R
H
I
G
H
S
I
M
O
F
F
O
N
H
I
-
P
O
W
E
R
H
I
G
H
S
I
M
O
F
F
O
N
M
E
L
T
H
I
G
H
O
F
F
O
N
S
I
M
H
I
G
H
O
F
F
O
N
O
F
F
O
N
S
I
M
H
I
G
H
O
F
F
O
N
S
I
M
H
I
G
H
B
R
I
D
G
E
Z
O
N
E
2
Z
O
N
E
3
H
I
G
H
M
E
L
T
O
F
F
O
N
wolfappliance.com/specs
Induction and Electric Cooktops
IMPORTANT NOTE: T
his installation must be completed
by a qualified installer or Wolf factory certified service.
Read this entire installation guide prior to installation and
save for the local inspector’s reference. The homeowner
should keep this installation guide for future reference.
This appliance must be installed in accordance with
National Electrical Codes, as well as all state, municipal
and local codes. The correct voltage, frequency and
amperage must be supplied to the appliance from a dedicated, grounded circuit which is protected by a properly
sized circuit breaker or time delay fuse. The proper
voltage, frequency and amperage ratings are listed on the
product rating plate.
Record the model and serial numbers before installing the
cooktop. Both numbers are listed on the product rating
plate, located on the underside of the cooktop. Refer to
the illustrations below for location of the rating plate.
olf Induction or Electric Cooktop
W
Model Number
Serial Number
RATING PLATE
RATING PLATE
Induction cooktop. Electric cooktop.
Cooktop Specifications 6
Electrical Requirements
olf induction and electric cooktops have a 4'
W
flexible conduit and require a separate, grounded 3-wire
electrical supply with its own circuit breaker. Locate the
electrical supply within the shaded area shown in the
installation illustration for your specific model on the
following pages.
IMPORTANT NOTE: You must follow all National Electrical
Code regulations. In addition, be aware of local codes and
ordinances when installing your service.
IMPORTANT NOTE: Except for model CT30E-208/S,
performance may be compromised if the electrical supply
is less than 240 volts.
(1.2 m)
Induction Cooktops
CT15 I/S
Power Supply 240/208 V AC, 60 Hz
Service 20 amp
Max Connected Load 3.6 kW at 240 / 3.1 kW at 208
CT30 I/S AND C T30IU
Power Supply 240/208 V AC, 60 Hz
Service 40 amp
Max Connected Load 7.2 kW at 240 / 6.3 kW at 208
CT36 I/S AND C T36IU
Power Supply 240/208 V AC, 60 Hz
Service 50 amp
Max Connected Load 11.2 kW at 240 / 9.7 kW at 208
Electric Cooktops
CT15 E/S
Power Supply 240/208 V AC, 60 Hz
Service 20 amp
Max Connected Load 3.7 kW at 240 / 2.8 kW at 208
CT30 E-208/ S
Power Supply 208 V AC, 60 Hz
Service 40 amp
Max Connected Load 7.9 kW
CT30 E/S AND C T30EU
Power Supply 240/208 V AC, 60 Hz
Service 40 amp
Max Connected Load 8.1 kW at 240 / 6.1 kW at 208
CT36 E/S AND C T36EU
Power Supply 240/208 V AC, 60 Hz
Service 50 amp
Max Connected Load 10.5 kW at 240 / 7.9 kW at 208