Planning Information
Integrated Induction Cooktop
MODEL CT15I/S
Dimensions in parentheses are in
millimeters unless otherwise specified.
7/06
1
Model CT15I /S
Classic Stainless Steel
While induction cooking is new to North America, it
has been used in Europe for decades by professionals
and homeowners demanding the best in performance.
Cooking with this sleek 15-inch powerhouse is simply
the best way to cook. Electricity flows through a coil to
produce a magnetic field under the sleek black ceramic
top. When an iron or magnetic stainless steel pan is
placed on the surface, the magnetic field creates a
current in the pan, exciting the molecules and heating
the pan and not the cooktop. That's why the cooktop
stays cool to the touch and the food cooks efficiently.
In fact this unit is so efficient that it outperforms gas
and electric cooktops. There is no wasted heat because
energy is supplied directly to the cooking vessel so
nearly 90 percent of the energy gets used to cook.
You can keep sauces and chocolates melted at 50
watts of power, or with the touch of a finger, activate
the Hi-Power boost feature and boil water in half the
time you normally do.
The Wolf induction cooktop has it all.
The Wolf Model CT15I /S 15" (381)
integrated induction cooktop is available
with classic stainless steel trim finish.
Illuminated electronic
touch controls
Two induction
elements
Classic stainless
steel trim finish
True Simmer and melt
on both elements
Lock key and
universal off
Location of
rating plate
HIGH
OFF ON
HI-POWER
MELT
H
G
I
H
N
O
F
F
O
O
M
I
S
F
F
O
Planning Information
Integrated Induction Cooktop
MODEL CT15I/S
Dimensions in parentheses are in
millimeters unless otherwise specified.
Dimensions may vary by ±
1
/8" (3).
2
OVERALL DIMENSIONS
FEATURES
Integrated design allows for installation of
multiple cooktops or modules
Classic stainless steel trim finish
Easy-to-clean black ceramic glass surface
is resistant to scratching, staining, impact
and heat
Induction elements heat cookware, not the
glass, for a cooler, safer cooking surface
Cookware sensing—elements will not be
energized without an iron or magnetic stainless steel pan on the cooktop surface
Illuminated electronic touch controls with
graduated control lighting
High-efficiency elements deliver power and
control
Hi-Power mode boosts power on rear
element to 2200 W maximum power output
by diverting power from front element
Simultaneous operation of both elements at
1800 W power output each
True Simmer setting on both elements
Melt setting on both elements
Temperature limiter to ensure that safe
operating temperature of ceramic glass is
never exceeded
Child safety lock key and universal off
CSA certified for US and Canada
Two and five year residential warranty –
exclusions apply; warranty information can
be found on our website, wolfappliance.com
21"
(533)
OVERALL
DEPTH
15" (381)
OVERALL WIDTH
(64)
21/2"
Planning Information
Integrated Induction Cooktop
MODEL CT15I/S
Dimensions in parentheses are in
millimeters unless otherwise specified.
3
SPECIFICATIONS
Overall Cooktop Width 15" (381)
Overall Cooktop Height 21/2" (64)
Overall Cooktop Depth 21" (533)
Cooktop Cut-Out Width 133/8" (340)
Cooktop Cut-Out Depth 191/4" (489)
Minimum Cabinet Depth 223/4" (578)
Minimum Height Clearance 6" (152)
Element Maximum Power (front) 1800 W
(rear) 2200 W
Electrical Supply Requirements 240/ 208 V AC, 60 Hz
20 amp dedicated circuit
Conduit 4 ft (1.2 m) flexible 3-wire
Electrical Rating 3.4 kW at 240 V
2.6 kW at 208 V
Shipping Weight 30 lbs (14 kg)
Special Note Cooktop can be installed in combination
with other cooktops or modules
Specifications are subject to change without notice.
MODEL OPTION
Classic Stainless Trim CT15I /S
VENTILATION OPTIONS
30" (762) Cooktop or Pro wall
hood or liner
30" (762) or 45" (1143) downdraft
ventilation system
36" (914) Cooktop or Pro island
hood
For additional information, refer to the
Wolf Cooktop Ventilation or Pro
Ventilation sections of our website,
wolfappliance.com.
ACCESSORIES
Filler strip
Bracket supports for installation
of two integrated modules with
downdraft (Model DD30 only)
Accessories are available through your
Wolf dealer. To obtain local dealer
information, visit the Locator section of
our website, wolfappliance.com.
Model CT15I /S
Classic Stainless Steel
Planning Information
Integrated Induction Cooktop
MODEL CT15I/S
Dimensions in parentheses are in
millimeters unless otherwise specified.
4
INSTALLATION SPECIFICATIONS
DIMENSIONS
Cooktop Cut-Out Width 133/8" (340)
Cooktop Cut-Out Depth 191/4" (489)
Minimum Height Clearance 6" (152)
Minimum Cabinet Depth 223/4" (578)
Location of Electrical Within shaded area
See Installation Instructions shipped with unit for detailed specifications.
t
13" max
(330)
191/4" (489)
2"**
COOKTOP CUT-OUT
(64)
DEPTH
21/2"min
(64)
18"
(457)
2"*min (51)
CUT-OUT TO
COMBUSTIBLE
MATERIALS
(BOTH SIDES)
33" (838)
RECOMMENDED
CABINET WIDTH
133/8" (340)
COOKTOP CUT-OUT
WIDTH
6"
(152)
30" (762)
COUNTERTOP TO
COMBUSTIBLE
MATERIALS
ABOVE COOKTOP
36" (914)
STANDARD
FLOOR TO
COUNTERTOP
HEIGHT
NOTE: Application shown allows for installation of two 15" (381) modules side-by-side with 33" (838) recommended cabinet width. 18" (457)
recommended cabinet width for installation of single 15" (381) cooktop or module. *Minimum clearance from both side edges of cooktop cut-ou
to combustible materials up to 18" (457) above countertop. ** Minimum clearance from rear edge of cooktop cut-out to combustible materials up
to 18" (457) above countertop.
21/2"min
(64)
E
15"
(381)
133/8" (340)
COOKTOP CUT-OUT
WIDTH
FRONT OF COUNTERTOP
15"
(381)
191/4" (489)
COOKTOP
CUT-OUT DEPTH
Planning Information
Integrated Induction Cooktop
MODEL CT15I/S
Dimensions in parentheses are in
millimeters unless otherwise specified.
5
INSTALLATION NOTES
Refer to the illustrations and specifications
for overall dimensions, cut-out dimensions and
installation specifics.
Wolf recommends using 33" (838) wide
cabinets for installation of two 15" (381)
modules side by side. An 18" (457) wide
cabinet is recommended for installation of a
single 15" (381) cooktop or module.
IMPORTANT NOTE: Review specific installation
instructions for product to product capabilities
If the 15" (381) integrated induction cooktop
is to be used with any combination of additional cooktop units or modules with a filler
strip, the cut-out width increases to 14" (356).
When multiple cooktops or modules are
installed side by side, refer to the countertop
cut-out dimensions on page 6.
IMPORTANT NOTE: A minimum height
clearance of 6" (152) is required. If a shelf is
installed below the unit, a 1" (25) gap at the
rear of the cabinet shelf is necessary to allow
for proper ventilation. Failure to do so could
result in decreased performance or product
damage.
A Wolf downdraft system, Cooktop or
Pro ventilation hood is recommended. When
installing a ventilation hood, refer to the specific
requirements of the hood for the minimum
dimension to countertop. Also refer to Ventilation Recommendations in the Cooktop Ventilation or Pro Ventilation sections of our website,
wolfappliance.com.
The Wolf 15" (381) integrated induction
cooktop requires a separate, grounded 3-wire
240/ 208 V AC, 60 Hz, 20 amp service with its
own circuit breaker. It has a 4' (1.2 m) flexible
3-wire conduit for connection at the electrical
supply. Locate electrical within the shaded area
shown in the Installation illustration on page 4.
You must follow all National Electrical Code
regulations. In addition, be aware of local codes
and ordinances when installing your service.
Refer to the installation instructions
shipped with each Wolf product for detailed
specifications.
This cooktop is intended for indoor use only.
Planning Information
Integrated Induction Cooktop
MODEL CT15I/S
Dimensions in parentheses are in
millimeters unless otherwise specified.
6
Countertop cut-out dimensions for installation of multiple cooktop units.
INTEGRATED MODULES—
MULTIPLE UNIT INSTALLATION
With Wolf's integrated modules, you have the
ultimate in customization. You can create your
own design by mixing and matching the various
components within this system. And when you
couple these modules with other cooktops
within the Wolf inventory you and your client will
truly understand freedom of choice.
Some Wolf integrated modules can be installed
together or with a 30" (762) or 36" (914)
cooktop. When multiple units are installed side
by side, the cut-out dimensions that are shown
in the illustration are derived by adding 1
1
/4" (32)
additional space for each additional unit, to give
you your total cut-out width. Refer to the illustration below for countertop cut-out dimensions
for installation of multiple cooktops.
IMPORTANT NOTE: Refer to the pages for each
specific integrated module for installation
limitations.
IMPORTANT NOTE: Where multiple cooktops
and/ or modules are installed side by side, each
unit must have its own separate recommended
electrical circuit. When multiple gas cooktops
and/ or modules are installed next to one
another, they can receive their gas supply from a
common line. However, each unit must have its
own regulator installed between the mainline
and the cooktop or module.
When two or more cooktops or modules are
installed together, an integrated module filler
strip is recommended. Contact your Wolf dealer
for information on this accessory component.
For electrical requirements, additional specifications and installation limitations, refer to the
Installation Notes on page 5.
IMPORTANT NOTE: Review specific installation
instructions for product to product capabilities.
593/4"
591/2"
501/4"
441/2"
441/4"
(1124) 30" COOKTOP AND ONE MODULE
291/4"
TWO MODULES WIDTH
14"
(356)
21/2"min
(64)
CUT-OUT
WIDTH
FRONT OF COUNTERTOP
(1518) FOUR MODULES WIDTH OR
(1511) 30" COOKTOP AND TWO MODULES OR
(1276) 36" COOKTOP AND ONE MODULE
(1130) THREE MODULES WIDTH OR
(743)
191/4"
(489)
CUT-OUT
DEPTH
Loading...