Sub Zero 7030527, 7040171, 7030802 Installation

Lock Kit Installation

subzero.com 800.222.7820

CONTENTS (Quantities double for dual installations.)

1 Lock

1 Screw, #10 x

2 Screw, #10 x ½ tamper proof

1 Cam, offset

1 Screw, wrench T20

2 Kickplate

1 Bracket, switch (freestanding models only)

∕8

INSTALLATION

1 Remove the kickplate and switch depressor by

extracting two screws from each component.

2 Remove the switch bracket by extracting two screws

then remove the wire connectors from the switch.

5 Insert the lock into the switch bracket then secure with

the nut provided. Refer to the illustration below.

6 Attach the offset cam to the lock using the

screw provided.

NUT

LOCK

Install lock.

7 Verify the offset aligns with the slot in switch bracket

Install offset cam.

CAM

then reattach the wire connectors to the switch.

8 Reinstall the switch bracket using the existing screws

then install the switch depressor using the tamper proof screws provided.

Remove switch depressor. Remove switch bracket.

3 For all models except freestanding models, skip to

step 5. For freestanding models, extract the switch from the switch bracket by removing two screws.

4 Install the switch into the freestanding switch bracket

provided using the two existing screws.

9 Install the kickplate. Use the black screws provided with

the unit to install a black toekick or the silver screws provided with this kit to install a silver toekick.

Test lock. Reinstall switch bracket.

Remove switch. Install switch.

7040172 REV-A 11/2014

page 1 of 1