Sub Zero 7030447 Installation

Undercounter Dual Installation

subzero.com 800.222.7820

Contents

DUAL INSTALLATION

3 Clip, Trim

7 Screw, #10 x ¾

1 Bushing

2 Tape

1 Bracket, Top

1 Bracket, Bottom

1 Trim, Center

1 Heater

1 Wire, Ground

1 Instructions

IMPORTANT NOTE: For outdoor units only. Use a power drill

to remove the 3 rivets that secure the trim to the handle side of each unit then discard trim. Refer to the illustration below.

Installation

1 Remove the paper backing from the tape on the back

of the heater.

3 Clip the ground wire to the bottom of the heater then

attach the ground wire to the unit using the ground screw. Refer to the illustration below.

4 Position the wires from the heater through the opening

in the unit tray then install the plastic bushing. Refer to the illustration below.

5 Attach the male plug from the heater into the female plug

supplied with the unit.

6 Use 4 screws provided to install the top bracket.

GROUND SCREW

BUSHING

2 Place heater panel approximately ¼" from the back of

the unit being installed on the right, then press ﬁrmly to secure. See illustration below.

RIVET

TRIM

Remove trim (UC-24RO only.) Install heater.

Install top bracket.Install bushing.

7 Use 2 screws to install the bottom bracket.

8 Install (3) trim clips on center trim, then place the trim

between both units and press to install.

Install bottom bracket.

Install center trim.

7030942 REV-A 03/2014

page 1 of 1