Sub Zero 7008911, 7008908, 7008902, 7008896, 7008893 Installation

Metal Front Panels

7004566 / Rev A / February, 2008

Page 1 of 4

CONT

AINS:

QTY

DESCRIPTION
1 Panel
1 Bag of Front Panel Clips
1 Instruction Sheet

FRONT P

ANEL

CLIP INSTALLATION PROCEDURE:

Insert the clips into the rectangular holes in the rear flanges of the front panel as shown in Figure 1, making sure
the 1/4” (6 mm) wide part of the clips is facing toward the outer edge of the panel as this will slide under the door
trim.

PANEL

(REAR VIEW)

PANEL CLIP

PANEL CLIP

Figure 1. Front Panel Clip Installation

NOTE: The clip installation is the same regardless of the panel.

(Over/under Refrigerator door panel shown)

1

2

3

DOOR

HANDLE-SIDE TRIM

SCREWS

SCREW COVER

METAL FRONT

PANEL

Figure 4. Door Metal Front Panel Installation

Metal Front Panels

7004566 / Rev A / February, 2008

Page 2 of 4

DOOR HANDLE-SIDE TRIM REMOVAL PROCEDURE:

1. At the top of the door, insert a flat blade screwdriver into the channel of the screw cover and push the cover
away form the handle-side trim so that it disengages from the handle-side trim (See Figure 2).

2. With a T-20, 6-lobe Torx type bit, extract the handle-side mounting screws and pull the trim from the door
(See Figure 3).

Figure 2. Screw Cover Removal

Figure 3. Handle-Side Trim Removal

DOOR

SCREW COVER

HANDLE-SIDE TRIM

HANDLE-SIDE TRIM

DOOR PANEL INSTALLATION PROCEDURE (See Figure 4):

1. Install the door front panel onto the door so that the panel clips slide under the door trim and the front panel
slides in over the door trim.

22. Reattach the handle-side trim.

3. Reinstall the screw cover.