Sub-Zero 7029157, 7025229, 7025228 Installation Guide

Contents

Tubular and Pro Handle Installation

subzero.com 800.222.7820

TUBULAR HANDLE

1 Handle

2 Standoff

2 Screw, #10–24 x 2"

2 Screw, #10–24 x 21/4"

2 Washer, at

2 Washer, star

1 Instructions

PRO HANDLE

1 Handle

2 Standoff

2 Screw, #10–24 x 21/4"

2 Screw, #10–24 x 21/2"

2 Washer, at

2 Washer, star

1 Instructions

Handle Installation

Panels thicker than 3/4" may require additional counter bore depth or longer bolts.

HANDLE LENGTH A

TUBULAR HANDLE

501/8" (1273) 471/8" (1197) 331/4" (845) 301/4" (768) 271/4" (692) 241/4" (616) 241/4" (616) 211/4" (540) 211/4" (540) 181/4" (464)

PRO HANDLE

483/8" (1229) 471/8" (1197) 311/2" (800) 301/4" (768) 251/2" (648) 241/4" (616) 221/2" (572) 211/4" (540) 191/2" (495) 181/4" (464)

FLAT

WASHER

STAR

WASHER

Determine the overall length of the handle. For pro handles, the overall length includes the standoffs. Refer to the handle length chart and illustration for the center to center dimension (A), then mark and drill two 7/32" holes. Using a smaller bit to drill pilot holes will help ensure a proper t.

Counter bore panels so the bolt heads and washers are completely recessed. Place a star and at washer onto each bolt then insert the bolts through the panel. Refer to the illustration.

Insert the bolts through the standoffs and into the handle. Tighten bolts to secure the handle to the panel.

Hole location.

PANEL

Panel preparation (side view).

7026122 REV-A 02/2013

page 1 of 1