Sub Zero 0000043 Installation

4204720 - Stainless Steel Side Panel (Models 648PRO & 648PROG)

3758684 / Rev D / July, 2007

Page 1 of 1

PROCEDURE:

1. Attach the six side panel brackets to the side of the unit by align the holes of each bracket with the mounting
holes in the unit’s side, then insert the #8 Rivgrip screws through the holes in the brackets, into the mounting
holes using a T-20 Torx drive.

2. To hang the side panel, lift it above the bracket, push it against the unit’s side, then let it slide down so that
the panel mounting slots fit over and hook onto the brackets.

3. Make sure all brackets are engaged by lightly pulling outward on panel while checking for proper position.

CONT

AINS: QUANTITY DESCRIPTION

1 Stainless Steel Side Panel
6 Side Panel Bracket

18 Screws, # 8 Rivgrip

2 Sound deadening Foam Pad
1 Instructions

NOTE: The protective tape coating must be peeled off front of stainless steel panels before installing.
NOTE: There is sound insulating foam tape applied to the back of the panel that should not be removed.
NOTE: If a top panel will also be installed, the side panels must be installed first.

Metal panels may have sharp edges which could inflict serious personal injury. Use care when handling. This
sales accessory package is heavy and unstable. If it were to fall on someone, it could cause serious injury. Lay
it flat when unpacking.

Figure 1

Stainless Steel Side Panel

Panel Mounting
Slots (6)

Sound Insulating

Foam Pad

Bracket Mounting
Holes (6 sets of 3)

Side Panel
Brackets (6)

#8 Rivgrip Screws
(3 each bracket)