SUBARU Mobile Internet Installation Instruction

Item

Description

Qty.

1

12V adapter plug, RA,13” L

1 2 Well Nut, Rubber, M5

4 3 Harness hold-down clip

1 4 Screw, SS, Phillips, M5, 20mm L

4 5 Foam tape, 1” x 2” x 1/16”, Black

1 6 Alcohol wipe

1 7 Mobile Internet Mounting Dock

1 8 Mobile Internet Main Housing

1

1 3 2 4 6

5

2. Tools Required

#2 Drive

Right angle drill with
3/8” drill bit

Part Number: H001SAJ200

Masking
Tape

Deburring
tool

7

8

Description: Outback Mobile
Internet Installation Instructions

Note: This product is not compatible with Remote Engine Starter Accessory.

1. Kit Contents

PN: H001SAJ200 REV. - 3/10/10 SUBARU OF AMERICA 1

3. Instructions: Outback

1. Turn car ignition to the off position until
requested to turn on in step 10.

2. On the driver’s side rear quarter-panel
interior trim, place and tape the provided
template as shown (Cut out template on
page 10), aligning the template into the 3
corners. Once aligned, mark hole centers
and remove template prior to drilling. Using
a right angle drill, drill 4 holes with a 3/8” drill
with a 1/8” drill stop. Remove burrs from
holes if necessary. (Pleas e not e bott o m
dock must clear the rear cargo tray.)

3. Using the provided four rubber well
nuts, push nuts into all four holes until
seated against the quarter panel interior
trim.

PN: H001SAJ200 REV. - 3/10/10 SUBARU OF AMERICA 2