Page 1
LED DIMMABLE LIGHTED MIRROR
Description
30in.W×36in.H×1.77in.D copper-fr ee silver L ED Dimmab le Lighted Mirror
ETL certi fied
4 sides frosted edges（1.18in）,sealed by PC cov er
LED 120 pins/meter, 2835 LED light strip wrap ped aroun d aluminum frame
Lume ns CRI Temper ature ( K)
4782 >80
Dimmable Light
To turn the mirror light ON, push the “ ”sensor on the mirror,
hold on three seconds to begin dimmable, to fi nd your des ired
brightness, continue pushing the“ ”senso r, the light w ill
turn from 100% to 10%. Repeat until desired br ightnes s is
discovered.
Anti-fog Pad
Size:11 4/5in×16 1/2 in
Turn on the L ED light, p ush the sen sor on the mirror in
order to activate the anti-fog pad .When the anti-fog i s on,
will keep an area roughly the size of the pad fog fr ee.
Turn off the LED light, anti-fog pad is off, wil l not keep
an area roughly of the pad fog free.
6400 K(+/- 300K)
MO DEL 75 -103
C
US
D
LED DIMMABLE LIGHTED MIRROR
screws
4
Page 2
MO DEL 75 -103
LED DIMMABLE LIGHTED MIRROR
C
US
D
INSTALLATION INSTRUCTIONS
1、Make certain the wall is solid, and use the flexible rule to measure the centre distance
hardy holes on the mirror frame (“a” and “b” in Fig. 1).
2、Use the flexible rule to measure the centre distance between two hardy holes on the wall
“b” in Fig. 1), and mark them out with a pencil.
3、Choose the churn drill with an appropriate drill bit to make two holes at the marked
special ceramic drill if the wall surface is made of ceramic tiles.
4、Use the hammer to strike the expansion rubber plug in accessory bag into the holes on
then use the screwdriver to tighten the screws into the holes (exposure for 8 – 12mm).
5、Switch off the power, and then use a terminal block to connect the three-core exposed
reserved on the wall (see details in wiring Diagram)
6、Hang the product on the screw crossing two hardy holes to fix it.
7、Finally, switch on the power, and then touch the “Switch” sign with a finger on the
the products to turn the mirror light ON, push the Sensor on the mirror, to find .
your desired brightness,
continue pushing the sensor, the light will turn from100% to10%,repeat until desired brightness is discovered.
LED DIMMABLE LIGHTED MIRROR
between two
(“a” and
places, and use a
the wall, and
wires with those
lens to test
Page 3
MO DEL 75 -103
LED DIMMABLE LIGHTED MIRROR
C
US
D
b(
ve
rt
ica
l
t
y
pe
）
25"1/8
31"1/8
Rear-view mirror
a(horizontal type)
Fig. 1
LED DIMMABLE LIGHTED MIRROR
Loading...