www.studiodesk.net
ASSEMBLY MANUAL
PRO LINE S and SL
Check our Step by step video assembly manuals on our
Youtube chanel https://www.youtube.com/c/StudioDesk
Links can be found in User manual section on our website.
NOTE: In order to avoid injury or damages,
please do not try to assemble your desk alone.
!
PRO - Line is a heavy desk, which requires
at least two people to carry out assembly.
Please assemble on soft surface to avoid
scratches to the lacquer.
The Desk You Deserve
Thank you for making StudioDesk your desk of choice!
Before beginning assembly of your desk, let’s get familiar with the parts you have received in your package.
Please match the corresponding numbers on this page with the drawings.
Wooden parts
1. Main Desk Surface
2. Left and right desk surfaces
3. Strengthening boards
4. Rack top mask
5. Cable management
6. Video monitor’s shelf
7. Outer Legs - (left and right)
8. Inner legs - (left and right)
7
L
R
2
R
L
1
4
3
8
5
6
L
R
9
Hardware
1
Metal corner
20 pcs
2
Desk tips
8 pcs
3
M6 Screw
98 pcs
4
M6 Screws for
Rack rails
4 pcs
5
Wooden Dowels
34 pcs
6
Rack rails 8 U
4 pcs
7
Stickers
inserts
1 pc
8
Cable inlays for
Legs 2 pcs
FE 80
9
Washers M6
7 pcs
to cover
Black
Tools needed - Phillips screwdriver
Cage nuts and
10
M6 x 16 Screws
16 pcs each
11
Strengthening bar 1300 mm
When SL Version ADD
Strengthening bar 1462 mm
M6 Screw
7 pcs
Washers M6
www.studiodesk.net
1
Insert dowels (13) into the holes as
shown in the illustration. Use a
rubber hammer if needed.
Step One
2
Step Two
3
Step Three
Fix assembled parts together using
metal corners (9) and M6 screws (11)
as shown in the illustration.
Place inner leg to assembled section onto the
4
Assemble parts together on dowels
as shown in the illustration.
8
10
Step Four
corresponding holes on the leg. Take special care
to avoid scratching the lacquered surface. Push the
Inner leg down until the dowels seat properly in their
respective holes. Use a rubber hammer, if needed.
Usually it is not necessary.
5
Once dowels are in place and boards sit tight to the leg,
use metal corners (9) and M6 screws (11) to fix the
Step Five
8
middle section to the leg. Repeat procedure with right
Module. Note! Turn the metal corner’s shorter edge downward
Step Six
7
6
Step Seven
Install metal brackets on the both side modules
taking into consideration height of your top shelf.
Screw the desk tips to the legs on both left and right module.
8
Step Eight
Bring two modules closer and connect it with middle parts
one by one starting with bottom. Desk surfaces will stand
freely on metal brackets. Push the side modules closer
until the dowels seat properly in their respective
holes in legs and and desk surfaces are tight to each
other.
10
9
Do not do that step alone. You’ll need help of another person!
Step Nine
Fix middle section to the legs using metal corners (9)
and M6 screws (11).
Install metal bar to top shelf using M6 Screws.
10
Install rack rails (14) to the legs using
M6 screws (12). Positions for the
screws are predefined.
Step Ten
Loading...