Studebaker SB6085 Owner's Manual

E-1

WARNING

TO PREVENT FIRE OR SHOCK HAZARD, DO NOT USE THIS PLUG WITH AN

EXTENSION CORD, RECEPTACLE OR OTHER OUTLET UNLESS THE BLADES CAN

BE FULLY INSERTED TO PREVENT BLADE EXPOSURE. TO PREVENT FIRE OR

SHOCK HAZARD, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE.

The Caution Marking and rating label are located at the back enclosure of the apparatus.

IMPORTANT SAFETY INSTRUCTIONS

1. Read these instructions.

2. Keep these instructions.

3. Heed all warnings.

4. Follow all instructions.

5. Do not use this apparatus near water.

6. Clean only with dry cloth.

7. Do not block any ventilation openings. Install in accordance with the manufacturer’s
instructions.

8. Do not install near any heat sources such as radiators, heat registers, stoves, or
other apparatus (including amplifiers) that product heat.

9. Do not defeat the safety purpose of the polarized or grounding-type plug. A polarized
plug has two blades with one wider than the other. A grounding type plug has two
blades and a third grounding prong. The wide blade or the third prong is provided for
your safety. If the provided plug does not fit into your outlet, consult an electrician for
replacement of the obsolete outlet.

10. Protect the power cord from being walked on or pinched particularly at plugs,
convenience receptacles, and the point where they exit from the apparatus.

11. Only use attachments/accessories specified by the manufacturer.

12. Use only with a cart, stand, tripod, bracket, or table recommended by
the manufacturer, or sold with the product. When a cart is used, use
caution when moving the cart/apparatus combination to avoid injury
from tip-over.

13. Unplug this apparatus during lightning storms or when unused for a
long periods of time.

14. Refer all servicing to qualified service personnel. Servicing is required when the
apparatus has been damaged in any way, such as power-supply cord or plug is
damaged, liquid has been spilled or objects have fallen into the apparatus, the
apparatus has been exposed to rain or moisture, does not operate normally, or has
been dropped.

E-2

15. This appliance shall not be exposed to dripping or splashing water and that no object
filled with liquids such as vases shall be placed on the apparatus.

16. Do not overload wall outlet. Use only power source as indicated.

17. Use replacement part as specified by the manufacturer.

18. Upon completion of any service or repairs to this product, ask the service technician
to perform safety checks.

19. Power Sources - This product should be operated only from the type of power source
indicated on the marking label. If you are not sure of the type of power supply to your
home, consult your product dealer or local power company. For products intended to
operate from battery power, or other sources, refer to the operating instruction.

20. Object and Liquid Entry - Never push objects of any kind into this product through
openings as they may touch dangerous voltage points or short-out parts that could
result in a fire or electric shock. Never spill liquid of any kind on the product.

21. Damage Requiring Service - Unplug this product from the wall outlet and refer
servicing to qualified service personnel under the following conditions:
a) When the power-supply cord or plug is damaged,
b) If liquid has been spilled, or objects have fallen into the product,
c) If the product has been exposed to rain or water,
d) If the product does not operate normally by following the operating instructions.

Adjust only those controls that are covered by the operating instructions as an
improper adjustment of other controls may result in damage and will often require
extensive work by a qualified technician to restore the product to its normal

operation.
e) If the product has been dropped or damaged in any way, and
f) When the product exhibits a distinct change in performance - this indicates a

need for service.

22. Mains plug is used as disconnect device and it should remain readily operable during
intended use. In order to disconnect the apparatus from the mains completely, the
mains plug should be disconnected from the mains socket outlet completely.

23. Excessive sound pressure from earphones and headphone can cause hearing loss.

24. Minimum distances of 10 cm around the apparatus for sufficient ventilation.

25. The ventilation should not be impeded by covering the ventilation openings with
items, such as newspapers, table-cloths, curtains, etc.

26. No naked flame sources, such as lighted candles, should be placed on the
apparatus.

27. The use of apparatus in moderate climates.

SAVE THESE INSTRUCTIONS

E-3

CAUTION

Follow the advice below for safe operations.

ON PROTECTION AGAINST LASER ENERGY EXPOSURE

 As the laser beam used in this compact disc player is harmful to the eyes, do not

attempt to disassemble the casing.

 Stop operation immediately if any liquid or solid object should fall into the cabinet.
 Do not touch the lens or poke at it. If you do, you may damage the lens and the player

may not operate properly.

 Do not put anything in the safety slot. If you do, the laser diode will be ON when the CD

door is still open.

 If the unit is not to be used for a long period of time, make sure that all power sources

are disconnected from the unit. Remove all batteries from the battery compartment.

 This unit employs a laser. The use of controls or adjustment or performance of

procedures other than those specified here may result in exposure to hazardous
radiation.

Caution:

- Any use of the controls or performing any of the procedures in a way other than those specified

herein may result in hazardous radiation exposure.

- This unit should not be adjusted or repaired by anyone except qualified service personnel.

ON PLACEMENT

 Do not use the unit in places which are extremely hot, cold, dusty or humid.
 Place the unit on a flat and even surface.
 Do not restrict the air-flow of the unit by placing it in a place with poor ventilation, by covering it

with a cloth or by placing it on a carpet.

ON CONDENSATION

 When left in a heated room where it is warm and damp, water droplets or condensation may

form inside the unit.

 When there is condensation inside the unit, the unit may not function normally. Let it stand for

1 to 2 hours before turning the power on, or gradually heat the room up and dry the unit before
use.

PRECAUTION FOR USE

 UNPACK ALL PARTS AND REMOVE PROTECTIVE MATERIAL.
 DO NOT CONNECT THE UNIT TO THE MAINS BEFORE CHECKING THE MAINS

VOLTAGE AND ALL OTHER CONNECTIONS HAVE BEEN MADE.

 DO NOT COVER ANY VENTS AND MAKE SURE THAT THERE IS A SPACE OF

SEVERAL CENTIMETERS AROUND THE UNIT FOR VENTILATION.

E-4

COMPLIANCE WITH FCC REGULATIONS

FCC ID: 2ANXU-SB6085

This device complies with Part 15 of the FCC Rules. Operation is subject to the following

two conditions:

(1) this device may not cause harmful interference, and

(2) this device must accept any interference received, including interference that may

cause undesired operation.

NOTE : This equipment has been tested and found to comply with the limits for a Class B

digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to

provide reasonable protection against harmful interference in a residential installation.

This equipment generates, uses and can radiate radio frequency energy and, if not

installed and used in accordance with the instructions, may cause harmful interference to

radio communications. However, there is no guarantee that interference will not occur in

a particular installation. If this equipment does cause harmful interference to radio or

television reception, which can be determined by turning the equipment off and on, the

user is encouraged to try to correct the interference by one or more of the following

measures:

- Reorient or relocate the receiving antenna.

- Increase the separation

between the

equipment and receiver.

- Connect the equipment into an outlet on a circuit different from that to which the

receiver is connected.

- Consult the dealer or an experienced radio/TV technician for help.

Changes or modifications not expressly approved by the party responsible for

compliance could void the user's authority to operate the equipment.

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled

environment. This equipment should be installed and operated with minimum distance

20cm between the radiator & your body.

CAUTION: Changes or modifications

not ex

pressly approve

d by

the party

responsible for compliance could void the user’s authority to operate
the equipment.

PROTECT YOUR FURNITURE

This model is equipped with non-skid rubber 'feet' to prevent the product from moving

when you operate the controls. These 'feet' are made from non-migrating rubber material

specially formulated to avoid leaving any marks or stains on your furniture. However

certain types of oil based furniture polishes, wood preservatives, or cleaning sprays may

cause the 'feet' to soften, and leave marks or a rubber residue on the furniture. To

prevent any damage to your furniture we strongly recommend that you purchase small

self-adhesive felt pads, available at hardware stores and home improvement centers

everywhere, and apply these pads to the bottom of the rubber 'feet' before you place the

product on fine wooden furniture.

E-5

DEAR STUDEBAKER® CUSTOMER

Selecting fine audio equipment such as the unit you've just purchased is only the start of your

musical enjoyment. Now it's time to consider how you can maximize the fun and excitement your

equipment offers. This manufacturer and the Electronic Industries Association's Consumer

Electronics Group want you to get the most out of your equipment by playing it at a safe level.

One that lets the sound come through loud and clear without annoying blaring or distortion and,

most importantly, without affecting your sensitive hearing.

Sound can be deceiving. Over time your hearing "comfort level" adapts to higher volumes of

sound. So what sounds "normal" can actually be loud and harmful to your hearing. Guard against

this by setting your equipment at a safe level BEFORE your hearing adapts.

To establish a safe level:

 Start your volume control at a low setting.

 Slowly increase the sound until you can hear it comfortably and clearly, and without

distortion.

Once you have established a comfortable sound level:

 Set the dial and leave it there.

Taking a minute to do this now will help to prevent hearing damage or loss in the future.

After all, we want you listening for a lifetime.

We Want You Listening For a Lifetime

Used wisely, your new sound equipment will provide a lifetime of fun and enjoyment.

Since hearing damage from loud noise is often undetectable until it is too late, this

manufacturer and the Electronic Industries Association's Consumer Electronics Group

recommend you avoid prolonged exposure to excessive noise.

Customer's Record:

The serial number of this product is found on its back cover. You should note the serial

number of this unit in the space provided as a permanent record of your purchase to aid

in identification in the event of theft or loss.

Model Number: SB6085 Serial Number: ____________________

CONTENTS OF YOUR PRODUCT

Turntable unit x 1 set

45 RPM Adapter x 1 pc

Wooden legs x 4 pcs

AC Adapter (DC12V 2A) x 1 pc

User Manual x 1 pc
12 INCH TURNTABLE FELT MAT x 1 pc