EC21 load wiring is connected directly to the dimmer rack slot receptacle. Wires can
be routed down the back channel next to the dimmer receptacles so that they are out
of the way once the rack is assembled.
This “quick book” had been developed to give the electrical contractor a simple guide
to connect the system load wiring to the dimmer rack slot receptacle. Please connect
all load wiring according to your system drawings.
Load wiring is terminated to a proprietary connector. This connector incorporates a
mechanical ground pin longer than the power pins. This ensures that the dimmer
module is always earth grounded. All molded connector parts are made from a high
temperature plastic used by SSR block manufacturers
28-Jun-20052-450179-0202
EC21 Dimmer Rack
Strand Lighting
http://www.strandlighting.com
Load Wire Connector Charts
Slot Wiring Instructions
Allen set screws in the dimmer receptacles pins require a standard 1/8” Allen wrench.
Dimmer connector load pin specifications
Screw Type: ¼-20 Brass
Wire Gauge Range: 14- 6 AWG
Maximum Screw torque setting: 20 inch Lbs.
For complete installation details and instruction for this product, consult the Strand
Lighting EC21 Installation Manual.