
®
0.5A OUTPUT CURRENT
LOW SIDE OR HIGH SIDE SWITCH CON-
FIGURATION
6V TO 48V SUPPLY VOLTAGE RANGE
OVERLOAD AND SHORT CIRCUIT PROTEC-
TIONS
INTERN AL VO LT AGE CLA MP ING
SUPPLY AND OUTPUT REVERSAL PRO-
TECTION
THERMAL SHUTDOWN
GND AND VS OPEN WIRE PROTECTION
ADJUST ABLE DELA Y AT SWITCH O N
INDICATOR STATUS LED DRIVER
+5V REGULATED AUX. VOLTAGE
HIGH BURST IMMUNITY
DESCRIPTION
The TDE1707BFP is a 0.5A Integrated Power
Switch with up to 48V Power supply capability.
Two output configurations are possible:
- Load to Gnd. (High Side Mode)
- Load to V
Especially dedicated to proximity detectors, its in-
BLOCK DIAGRAM
(Low side Mode)
S
TDE1707BFP
INTELLIGENT POWER SWITCH
PRODUCT PREVIEW
SO8
ORDERING NUMBER: TDE1707BFP
ternal +5V supply can be used to supply external
circuits (See also AN495/0692). A signal is internally generated to block the In signal, and prevent
activation of the output switch, as long as an abnormal condition is detected. The power-on transition, as well as the chip overtemperature and
the output overcurrent, concurr to the generation
of such signal. A minimum delay of 25µs (Typ.
value) is added to the trailing edge of such signal
to ensure that a stable normal situation is present
when the signal disappears. The delay (of the disapperance of the block signal; no delay at its on
set) can be further increased connecting a capacitor between pin3 and ground. It can drive resistive or inductive loads.
September 2003
This is preliminary information on a new product now in development or undergoing evaluation. Details are subject to change without notice.
1/6

TDE1707BFP
PIN CONNECTION
(Top view)
ABSOLUTE MAXIMUM RATINGS
Symbol Parameter Value Unit
V
V
Supply Voltage 50 V
S
Supply Reverse Voltage 50 V
Sr
IO Output Current internally limited A
Regulated Voltage Pin 0 to 7 V
reg
Delay Cap. Surce Pin 0 to 5 V
Output Diff. Voltage 55 V
O
Input Voltage -10 to 50 V
i
Operating Temperature Range -25 to +85 °C
op
Storage Temperature -55 to 150 °C
stg
Power Dissipation internally limited W
tot
Energy Induct. Load 150 mJ
l
V
V
delay
V
V
T
T
P
E
THERMAL DATA
Symbol Description Value Unit
R
th j-amb
Thermal Resistance Junction-ambient Max. 150 °C/W
2/6

TDE1707BFP
= 24V; Tj = –25 to +85°C, unless otherwise specified)
8-2
(V
S
= –48V 1.5 mA
SR
= I
= 0; Vi < 2V;
reg
led
V
= 6 to 48V
S
Io = 500mA 1.1 1.6 V
= 10mA 55 70 V
CL
100 300
V
< 2V; Vo = 0 to Vs (Pin 8)
i
< 5mA 4.5 5 5.5 V
reg
V
= 48V
s
< 2V; RL < 1KΩ 10 µA
i
1.5 mA
100
6
4
ELECTRICAL CHARACTERISTICS
Symbol Parameter Test Condition Min. Typ. Max. Unit
7 Supply Voltage 6 48 V
V
s
Isr 7 Supply Reverse Current V
7 Quiescent Current I
I
q
Io 8/2 Output Current Vs = 6V to 32V 500 mA
8/2 Output Current Vs = 32V to 48V 300 mA
I
o
V
8/2 Output Voltage Drop V
sat
8/2 Output Voltage Drop V8-2 Io = 300mA 1.5 V
V
sat
8/2 Short Circuit Current 0.7 1.5 A
I
sc
V
8/2 Internal Voltage Clamp I
cl
8/2 Output Leakage 0 (Pin 2)
I
olk
5 Input Voltage Threshold 2 3 V
V
ith
5 Input Threshold Hysteresis 300 mV
V
ihis
I
5 Input Current Vi = 5V 2 5 µA
lk
6 Regulated Output Voltage I
V
reg
I
6 Short Circuit Regulated 6 30 50 mA
scr
6 Ouput Regulator Current Vs = 35V
I
reg
I
1 Current Surce Sink Led Driver Output ON (±) 234mA
old
1 Voltage Drop Led Driver Ios = 2mA (±)1.21.6V
V
old
Oldlk 1 Lead Driver (off) Leak. V
I
3 Del. Cap. Charge Current TJ = 25°C 246µA
dch
V
3 Delay Voltage Trigger TJ = 25°C4V
dth
µA
µA
mA
mA
APPLICATION I NFORMATION
(See Application
Circuit)
The LED driver tells the output status.
It can source or sink current (I
= 3mA), ac-
old typ
cording to the output configuration chosen.
The thresholds, represented by the output comparator in the Block Diagram, are set at about
1.5V - 2V.
For instance, in the High Side Load case of the
= 24V; RL = 48Ω; TJ = 25°C)
DYNAMIC CHARACTERISTICS
t
t
d min
t
on
t
off
don
Propagation Turn on Time Vi = 0 to 5V 15 µs
Propagation Turn off Time Vi = 5 to 0V 15 µs
Delayed Turn on Time / nF
Delay Capacitor
Minimum Delayed ton
Delay Capacitor = 0
(V
S
Application Circuit, when the voltage on pin 8 (the
output) differs from V
less than 1.5V, the output
CC
is sensed in "OFF" state and the LED driver is
disabled.
If instead pin 8 differs from V
more than 3V (the
CC
output comparator threshold value plus the drop
voltage on the LED), then the output is sensed
"ON" and the driver will force the current on the
LED.
0.65 1 2 ms
25 µs
3/6

TDE1707BFP
APPLICATION CIRCUIT
Figure 1:
Input Thresholds Voltage vs.
Temperature (V
= 24V)
S
Figure 2:
Saturation Voltage vs. Temperature
= 24V; IO = 500mA)
(V
S
Figure 3:
Quiescent Current) vs.Temperature
(V
= 24V)
S
4/6

TDE1707BFP
DIM.
MIN. TYP. MAX. MIN. TYP. MAX.
A 1.75 0.069
a1 0.1 0.25 0 .004 0.010
a2 1.65 0.065
a3 0.65 0.85 0.026 0.033
b 0.35 0.48 0 .014 0.019
b1 0.19 0.25 0.007 0.010
C 0.25 0.5 0.010 0.020
c1 45° (typ.)
D (1) 4.8 5.0 0.189 0.197
E 5.8 6.2 0.228 0.244
e 1.27 0.050
e3 3.81 0.150
F (1) 3.8 4.0 0.15 0.157
L 0.4 1.27 0.016 0.050
M 0.6 0.024
S8° (max.)
(1) D and F do not include mold flash or protrusions. Mold flash or
potrusions shall not exceed 0.15mm (.006inch).
mm inch
OUTLINE AND
MECHANICAL DATA
SO8
5/6

TDE1707BFP
Information furnishe d is beli eved to be accu rate and reliable. However, STMicroelec tronics assumes no res ponsibility for the consequences
of use of such i nformation nor for any i nfringement of patents or ot her rights of third par ties which may result from its use. No license i s
granted by imp lication or otherwi se under a ny patent or patent rights of STMicro electronics . Speci fications ment ioned in this publicat ion are
subject to change without notic e. This public ation supers edes and replaces all information prev iously supplied. STMic roelec tronic s products
are not authorized for use as critical components in life support devices or systems without express written approval of STMicroelectronics.
The ST logo is a registered trademark of STMicroelect roni cs.
All other names are the property of their respective owners
© 2003 STMicroelectronic s - All rights rese rved
STMicroelectronics GROUP OF COMPANIES
Australia – Belgium - Brazi l - Canada - China – Czec h Republ i c - Finland - France - Germany - Hong Kong - India - Israel - Italy - Ja pa n -
Malaysia - Malta - Morocco - Singapore - Spain - Sweden - Switzerland - United Kingdom - United States
www.st.com
6/6