STMicroelectronics STSW-LLL010FW User Manual
Hardware
Abstraction
Hardware
User interfaces
and utilities
Button interface
LED sequence code examples
Demonstration
STM32F042
STEVAL-LLL010V1
STM32Cube
STSW-LLL010FW
Data brief
Firmware for evaluation kit based on LED8102S LED driver with code examples
for LED sequences
Features
Manual mode control of LEDs through button interface
•
• Demo mode with several of automatic LED sequences
• Sample code to help users speed up custom application development
• Based on STM32Cube common architecture for STM32 microcontrollers
Description
The STSW-LLL010FW firmware runs on the STEVAL-LLL010V1 evaluation kit
control board microcontroller to allow manual control of both the white LED and RGB
LED sides of the kit LED panel board, as well as several demonstration sequences
from the control board button interface. The demonstration sequences can be used
as code examples to help develop custom firmware for specific applications, which
can be loaded onto the microcontroller through the control board SWD interface.
In Manual mode, the button interface can be used to control the LEDs on the white
LED side or the RGB LED side of the kit LED panel board.
On the white LED side, pressing the SEL (SW3) button on the control board toggles
between the individual LEDs (indicated by a brief flashing sequence), and the UP
(SW1)/DOWN (SW2) buttons allow brightness regulation. Pressing the FADE (SW5)
button gradually fades all the LEDs in and out.
On the RGB LED side, the SEL (SW3) button selects an RGB or white channel,
which is indicated by a brief flashing sequence. The UP (SW1)/DOWN (SW2) button
can then control the corresponding LED brightness. Pressing the FADE (SW5) button
Product summary
evaluation kit for
LED8102S 8-channel
LED driver with direct
switch control
8-channel LED driver
with direct switch control
firmware for STEVALLLL010V1 with
demonstration
examples
Applications
STEVALLLL010V1
LED8102S
STSWLLL010FW
LED Lighting
and Controls
Human
Machine
Interface
gradually fades all the LEDs in and out.
The DEMO button (SW4) toggles between Manual mode and two automatic
sequences for both the white and RGB sides of the LED panel board.
The first white LED demo fades each LED channel in and out individually at varying
speeds, while the user can control global brightness through the UP (SW1)/DOWN
(SW2) buttons. In the second white LED demo, each LED channel fades in and out
simultaneously at different speeds, followed by a slow fading sequence applied
globally.
The first RGB LED demo cycles continuously between three white points colors
indicated by the three white LEDs at the bottom of the RGB panel, while the user can
control global brightness through the UP (SW1)/DOWN (SW2) buttons. The second
RGB LED demo gradually changes the LED colors from blue to green to red.
DB4195 - Rev 1 - July 2020
For further information contact your local STMicroelectronics sales of
fice.
www.st.com
Revision history
able 1. Document revision history
T
Date Version Changes
06-Jul-2020 1 Initial release.
STSW-LLL010FW
DB4195 - Rev 1
page 2/3
Loading...