Stir-Pak 700-5410 Instruction Manual

OPERATING MANUAL

MIXER

SERIES 20

MODEL NO. 700-5410

A dual-shaft Mixer, with a detached Controller designed to blend high

and low viscosity materials in large or small batches.

Barnant Company

28W092 Commercial Avenue

Barrington, Illinois U.S.A.60010-2392

[phone]

[phone] (Fax)

800-637-3739

www.barnant.com

e-mail: [e-mail]

A-1299-0480

Edition 04

W ARRANTY

The Manufacturer warrants this product to be free from significant
deviations from published specifications. If repair or adjustment is
necessary within the warranty period, the problem will be corrected at
no charge if it is not due to misuse or abuse on your part as determined
by the Manufacturer. Repair costs outside the warranty period, or those
resulting from product misuse or abuse, may be invoiced to you.

The warranty period for this product is noted on the Warranty Card.

PRODUCT RETURN

To limit charges and delays, contact the seller or Manufacturer for
authorization and shipping instructions before returning the product, either
within or outside of the warranty period.When returning the product, please
state the reason for the return. For your protection, pack the
product carefully and insure it against possible damage or loss. Any dam­ages resulting from improper packaging are your responsibility.

TECHNICAL ASSISTANCE

If you have any questions about the use of this product, contact the
Manufacturer or authorized seller.

Printed in U.S.A.

041198

17

TABLE OF CONTENTS

Title Page

SAFETY PRECAUTIONS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2

INTRODUCTION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3

READOUTS AND CONTROLS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3

DESCRIPTION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3

INSTALLATION AND SETUP PROCEDURE . . . . . . . . . . . . . . . . . . . . .5

Installation Using a Support Stand . . . . . . . . . . . . . . . . . . . . . . . .6

Installation using a Tank Clamp . . . . . . . . . . . . . . . . . . . . . . . . . .8

OPERATION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .11

MAINTENANCE AND TROUBLESHOOTING . . . . . . . . . . . . . . . . . . . .12

Motor Brush Check/Replacement . . . . . . . . . . . . . . . . . . . . . . .12

Cleaning the Mixer/Controller System . . . . . . . . . . . . . . . . . . . .12

Replacement Parts . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .12

Troubleshooting . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .13

ACCESSORIES . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .15

SPECIFICATIONS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .15

WARRANTY . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .17

PRODUCT RETURN . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .17

TECHNICAL ASSISTANCE . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .17

JACOBS–Reg TM Power Tool Holders, Inc.
Trademarks bearing the ® symbol in this publication
are registered in the U.S. and in other countries.

SPECIFICATIONS (Cont.)

Maximum Current: Controller: 0.8A,

shorted output condition

Mixer Shaft Interface: JACOBS-type chuck with key

accepts 5/16 in to 3/8 in dia shaft

Torque:

High Speed Shaft 7 in-oz continuous
Low Speed Shaft 100 in-oz continuous

140 in-oz intermittent

Speed Regulation: +/- 1% Line Regulation

+/- 2% Load Regulation

+/- 10% Warm-up dr ift
Enclosure Rating: IP53 per IEC 529
Mixer Head Rating: IP24 per IEC34-5
Humidity: 0% to 90% non-condensing
Display: Green LED
Fuse: 1.5 Ampere Slo-blo

(internal)
Dimensions:

Motor: 5-3/4 in L x 3-1/2 in D
Controller: 7 in W x 3-3/16 in H x 4-7/8 in D

Weight:

Motor: 4 pounds
Controller: 1-3/8 pounds

16