Stinger Smart RGB LED Controller SPXRGBC User Manual
SMART RGB LED CONTROLLER
SPXRGBC
Universal, waterproof, RGB controller with Bluetooth Control.
Before you start, review directions completely. If your vehicle is not pre-wired for accessory lighting, you may need a
switch and relay.
SPXRGBC
SPECIFICATIONS
•APP: EZ LED (iOS and Android)
•Operating temperature: -20~80°C
•Voltage: DC12V/24V,
•Distance: 10-20M
•Maximum output current: 10A
•Outputs: 4
Black - Ground
AMP
3
FUSE
Red - Battery (12V+)
Blue - Remote In (12V+)
Optional SPXRGBMF Solder Connector
NOTE: Do not exceed 10 AMPS
total across all 4 outputs.
Connect to optional to SPXRGB5 Universal
RGB LED Strip Lights
SMART RGB LED CONTROLLER (CONT)
WIRING DIAGRAM
The SPXRGBC can be wired to a
switch or to accessory power using
the BLUE lead. The RED wire should
be connected to constant power to
save the RGB light settings.
NOTE: Do not connect the Red and
BLUE to constant power and use the
app to turn the module on and off.
The module will draw power even
when turned off with the app.
GET THE EZ LED APP
Scan the QR Code, or visit Google Play or iTunes to
download the EZ LED app. Once the app is installed,
power up the SPXRGBC Module and open the app.
The module should auto-connect and be listed in the
Group Device List.
SPXRGBC
Connect BLACK wire to
Ground.
Black - Ground
Red - Battery (12V+)
Blue - Remote In (12V+)
Connect RED wire to constant
AMP
3
FUSE
power (12V+).
The BLUE wire can be connected
to a Switch (12V+) or connected to
vehicle’s Switched Power (12V+).
Do not connect to constant power.
Group
Device List
User Guide
SCAN for Apple iOS SCAN for Android
LIMITED WARRANTY:
Stinger warrants this product to be free of defects in materials and workmanship for a period of
one (1) years from the original date of purchase. This warranty is not transferable and applies
only to the original purchaser from an authorized Stinger dealer in the United States of America
only. Should service be necessary under this warranty for any reason due to manufacturing
defect or malfunction, Stinger will (at its discretion), repair or replace the defective product with
new or remanufactured product at no charge. Damage caused by the following is not covered
under warranty: accident, misuse, abuse, product modification or neglect, failure to follow
installation instructions, unauthorized repair attempts, misrepresentations by the seller. This
warranty does not cover incidental or consequential damages and does not cover the cost of
removing or reinstalling the unit(s). Cosmetic damage due to accident or normal wear and tear
is not covered under warranty.
INTERNATIONAL WARRANTIES:
Products purchased outside the United States of America are covered only by that country’s
Authorized Stinger reseller and not by Stinger. Consumers needing service or warranty information for these products must contact that country’s reseller for information.
EZ LED App
Stinger is a Power Brand of AAMP Global
15500 Lightwave, Clearwater, Florida 33760
P: 888-228-5560
support@stingerelectronics.com
www.stingerelectronics.com
© 2019 AAMP Global