Stiga T8570F, T8570W Owner's Manual

Be sure to write your model number and serial number here
for future reference. You can find these numbers printed on
the bottom of the table.

MODEL NO.: T8570W/F
DATE CODE : CPSIA#2-T8570W/F-_______-DO
PURCHASE DATE : _______________________

OWNER’S MANUAL

1. Read this manual carefully before starting assembly. Read each step completely before beginning
each step.

2. Some smaller parts may be shipped inside larger parts. Check inside all parts and cartons before
assembling or ordering parts.

3. If hardware is tightened too soon, mounting holes may not align and parts may not easily fit together.

Leave bolts slightly loose until you are instructed to tighten them.

4. Tools required for assembly: Wrenches or adjustable wrenches (not provided) are helpful.

5. To make assembly as easy as possible, place all parts of the table tennis in a cleared area and

remove the packaging material. Organize all parts as per parts identifier in the assembly manual.
Do not dispose of the packing material until assembly is completed.

6. Avoid scratching table tennis top and metal tube parts during the assembly process.

7. Assemble product on clean, level and flat surface.

8. Take time to correctly orientate parts exactly as per each assembly diagram.

9. Save this instruction in the event that the manufacturer has to be contacted for replacement parts.

READ ASSEMBLY, OPERATING AND SAFETY INSTRUCTIONS

CAUTION:

CAREFULLY! AT LEAST TWO ADULTS ARE NEEDED TO PUT
THIS TABLE TOGETHER!

Thank you for buying our product. We try hard to ensure that our products are of high quality and free o f problems, such as
Manufacturing defects or missing parts. However, if you have any problems with your new product, please DO NOT RETURN IT

TO THE STORE!

Please Do Not Return This Product To The Store!

Contact Escalade Sports customer service department at:
Phone: [phone] Toll-Free!

Fax: [phone] Toll-Free!
E-mail: [e-mail]

Please provide model number and/or part number of the product and/or part when you call or write. These numbers can be found on the
product, packaging, and/or in this Owner’s Manual.

Please visit our website at: www.escaladesports.com
ON-LINE TROUBLE SHOOTING TECHNICAL ASSISTANCE
ON-LINE PARTS REQUESTS FREQUENTLY ASKED QUESTIONS
ADDITIONAL ESCALADE SPORTS PRODUCT INFORMANTION

R

Mailing Address (correspondence only):
Escalade Sports
PO Box 889
Evansville, IN 47706

R

Escalade Sport products may be manufactured and/or licensed under the following patents.
6120397 , 5816957 , 5769744 , 5119741 , 4911085 , 4717157 , D460140 , D420563
Additional patents may be pending. One or more of the listed patents and/or pending patents may cover specific product.

R

C

2015 Escalade Sports

R

ONE YEAR LIMITED WARRANTY

This consumer warranty extends to the original consumer purchase of any ESCALADE® SPORTS Product
(hereinafter referred as the "Product").
WARRANTY DURATION: This Product is warranted to the original consumer purchase of a period of one (1) years from the original
purchase.
WARRANTY COVERAGE: ESCALADE SPORTS warrants to the original Consumer Purchaser that any Product of its manufacture is free
from defects in material and workmanship when used for the intended purpose under normal use and conditions. THIS WARRANTY IS
VOID IF THE PRODUCT HAS BEEN DAMAGED BY ACCIDENT, UNREASONABLE USE, NEGLIGENCE, IMPROPER SERVICE, FAILURE TO
FOLLOW INSTRUCTIONS PROVIDED WITH THE PRODUCT OR OTHER CAUSES NOT ARISING OUT OF DEFECTS IN MATERIAL
AND WORK
WARRANTY PERFORMANCE: During the above ONE (1) year warranty period, ESCALADE SPORTS

comparable model, and/or Product, or component thereof, for any product which may prove defective under normal use and proper care, and
which our examination shall disclose to our satisfaction to be thus defective, please contact our Warranty Dept.

MANSHIP.

shall repair or replace with a

1-866-873-3528 / Warranty Dept.

Escalade Sports, Inc. - P.O. Box 889, Evansville, IN 47706 - Attn: Warranty Dept.

®

Or E-mail us at:

[e-mail]

Or Write us at:

Other than shipping requirements no charge will be made for such repair or replacement of in-warranty Products. ESCALADE

®

SPORTS strongly recommends that the Product is insured for value prior to mailing.

WARRANTY DISCLAIMERS: ANY IMPLIED WARRANTIES ARISING OUT OF THIS SALE, INCLUDING BUT NOT LIMITED TO THE
IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE, ARE LIMITED IN DURATION TO THE
ABOVE ONE (1) YEAR WARRANTY PERIOD. ESCALADE SPORTS SHALL NOT BE LIABLE FOR LOSS OF USE OF THE PRODUCT

®

OR OTHER CONSEQUENTIAL OR INCIDENTAL COSTS, EXPENSES OR DAMAGES INCURRED BY THE CONSUMER OF ANY
OTHER USE.

Some states do not allow the exclusion or limitation of implied warranties or consequential or incidental damages, so the above
limitations or exclusions may not apply to you.

LEGAL REMEDIES: This warranty gives you specific legal rights and you may also have other rights which may vary from state to
state.

CAUTION

THIS IS A TABLE TENNIS TABLE. DO NOT SIT, STAND, LEAN, WALK OR JUMP ON TABLE!
FAILURE TO COMPLY WITH THIS CAUTION COULD RESULT IN PERSONAL INJURY AND/OR
PROPERTY DAMAGE!

UNLEVEL FLOORS

If table does not seem level, it is probably because floor is not level. Move table several inches (set table in
playing position) in different directions to find the best location for the table. If the floor is extremely
unlevel, table may not play or operate properly. If table is high in the center, shim up under the outer legs.

CARE AND MAINTENANCE

You havepurchaseda qualityproduct thatwill giveyouyears ofenjoyment. By followingthesesimplemaintenance stepsyou will addto thelife ofyournewtable.
The top(playingsurface) ofyour tableis ofaluminumconstruction. It canbeaffectedbyatmospheric conditions, meaning both temperature and humidity. This
may cause aslight sag or distortion as top expandsor contracts. This is normal and should not cause concern as it does not detract from the play or utility value
of the table.

STORAGEOFYOUR TABLE

Windgustscan blow overor unexpectedlyopen thetable; Store inprotected area. Whenyour table isnot inuse, it shouldbe folded up in a dry area.

CLEANINGYOUR TABLE

To clean your table use a soft damp NOTWET clothonly. To preventdamagetoyourtable'splayingsurface DONOT use any chemicals, abrasive, or cleaning
products onyour table's playing surface.

IMPORTANT: Periodically, lubricate allmoving parts, including pivot points, to assure smooth opening and closing.A light lubricant such as WD-40 is recomm­ended.

- 2 -

HARDWARE IDENTIFIER (To Scale)

H1 - 8 mm x 50 mm

Hex Head Bolt

(8 pcs)

H2 - 8.5 mm x 22 mm

Flat Washer

(16 pcs)

PARTS IDENTIFIER (Not to Scale)

P1 - Table Tennis Table Top

Frame Assembly

(2 pcs)

P2 - Leg with Casters

Assembly

(4 pcs)

H3 - 8 mm Nylon

Lock Nut

(8 pcs)

P3 - Connector

(8 pcs)

P4 - Net Post

(2 pcs)

WARNING:

CHOKING HAZARD

!

Small parts.
Not for children under
3 yrs.

- 3 -

P5 - Net (1 pc)

IMPORTANT NOTE: Place table half top with playing surface face down on a CLEAN flat surface
for ease of correct assembly and to prevent any scratches or blemishes to the playing surface.

PARTS REQUIRED

-

1 pc P1 Table Tennis Table Top Frame Assembly 4 pcs - H1 Hex Head Bolt
2 pcs - P2 Leg with Casters Assembly 8 pcs - H2 Flat Washer
4 pcs - P3 Connector 4 pcs - H3 Lock Nut

STEP 1:

Lay one piece P1 Table Tennis Table Top Frame Assembly flat with playing surface
facing down as shown in FIGURE 1A.

DETAIL A

Unlock the SAFETY LOCK as shown in DETAIL A and raise FRONT LEGS to a
vertical position and lock both hinges as shown in FIGURE 1B & DETAIL B.

This end is the front
of the table.

P1

This end is the middle of the table
and does not have white screen

FIGURE 1A

lines and close to Safety Latch.

DETAIL B

Front Leg.

Hinge Locked

Front Leg.

Safety Lock.

Push down on LOCK TAB
to release lock and pull up
on FRONT LEGS only.

Do not pull up middle legs
as this could cause damage
to the table.

Middle Leg.

PUSH UP

STEP 2:

Install P2 Leg with Casters Assembly with P3 Connectors using
H1 Hex Head Bolts, H2 Flat Washers and H3 Lock Nuts
as shown in FIGURE 2 & DETAIL C. Tighten this hardware.

Repeat procedure for other table top.

FIGURE 2

H3

H2

FIGURE 1B

DETAIL C

P2

P3

H2

H1

- 4 -

WARNING:

THIS STEP REQUIRES TWO OR MORE ADULTS.

VERY CAREFULLY TURN THE TABLE OVER AND SET IT ON

ITS LEGS. BE CAREFUL, THE TABLE IS VERY HEAVY.

PARTS REQUIRED

2 pcs - P4 Net Post
1 pc

- P5 Net

STEP 3:

Attach P4 Net Posts and P5 Net to the middle of the table halves as shown in FIGURE 3 and NET ASSEMBLY STEP.

NET ASSEMBLY STEP

STEP 1:

Attach P4 Net Posts
on the middle edge
of table halves.

STEP 2:

Rotate bottom thread
to release Net Post
Cap.

STEP 3:

Remove Net Post
Cap from the tube.

STEP 4:

Slide P5 Net inside
the tube.

STEP 5:

Close the tube using
Net Post Cap again.

FIGURE 3

STEP 6:

Secure Net Post Cap
by rotating bottom
thread again.

STEP 7:

Secure cord on Net
Post hook with knot.

P4

SIDE VIEW

Table Tennis Top

Table
Tennis
Top

Table Tennis
Top Bottom
Frame

FRONT
VIEW

NOTE:

Level table using
Leg Levelers.

IMPORTANT NOTE:

Be sure to break all four(4) hinges, using the palm
of your hand before folding table upright.
Lock hinges when table is in playing positions.

- 5 -