STI STI-V34104 Owner's Manual
- 1 -
4-Channel Voice Receiver
STI-V34104
HOW THE PRODUCT WORKS
The 4-Channel Voice Receiver is a multipurpose long-range receiver that works
with a wide range of STI Wireless Alert Series sensors. Most products can
achieve up to 1,000’ receiver range (line of site). Four zone indicators light up
to indicate a sensor has triggered. Selectable tones and voice messages are a
key feature. Sensors have default messages or program your own by choosing
up to four words or tones from a preprogrammed list. All voice messages are
available in English or Spanish. Receiver is intended for indoor use only.
EASY STARTUP:
Install batteries in sensor,
plug in receiver and listen
to instructions.
We protect the things that protect you.
- 2 -
BEFORE YOU START
Review detailed product specifications (Fig. 1 and 2)
Antenna Jack
· Internal antenna with product
· Use external for maximum range
Volume Control
Lamp Controller Output
· Works with STI Lamp Controller (STI-30104)
· 3.5mm mono jack, center negative
· 12VDC, 75mA 3 sec
Power Supply Jack (STI-34105)
· 12 VDC 500mA input
· Switching/regulated
· UL Class II, FCC, C minimum
Door to Programming Controls
Acknowledge Button
· Resets all flashing red zones
· Light flickers green as STI sensor
signal is detected
· Push to silence any auto message
Four Zone Light Indicators
· Solid Red - sensor is triggered
· Flashing Red - zone has triggered
in latching mode. Reset by pushing
acknowledge button, changes back
to green
· Yellow - sensor maintenance
required (tamper, low battery)
· Green - sensor programmed
· No light - sensor not programmed
Program Switch
Zone/Message
Selection Button
· Use to scroll through
default messages
Advanced Programming
Dip Switches
· In PROGRAM mode
switches 3-8 provide
access to 63
messages/tones
Fig. 1
Fig. 2
Stand
High Low
System Reset:
· Clears all programmed zones
- 3 -
ZONE PROGRAMMING PROCEDURES
Only receives wireless signals from the STI Wireless Alert Series products. Program up to 4
sensors or keyfobs. Does not allow programming into an occupied zone. Cannot program
the same sensor into more than one zone. The unit will state, “Please change to normal
mode if programming is completed.” (Repeats every 60 seconds.) Default language is English.
Move dip switch 1 to the “on” (up) position for Spanish.
MODES OF OPERATION
Set at time of programming by zone
Zone Latching: Dip Switch #2 ‘OFF’
When sensor is triggered, red zone light is solid. “Latching” let’s you know a zone was triggered,
but the alert has cleared (flashing red LED). To reset, push the acknowledge button.
Zone Auto Restore: Dip Switch #2 ‘ON’
“Auto-Restore” sounds when a zone has been triggered. Zone automatically restores to solid
green light without pressing acknowledge button.
Dip Switch Functions
DIP NORMAL MODE PROGRAM MODE
SWITCH
OFF (DOWN) ON (UP) OFF (DOWN) ON (UP)
1 — ENGLISH* SPANISH
2 — LATCHING* AUTO RESTORE
3 PRE-ALERT TONE* NO TONE TONE/WORD SELECT
4 — TONE/WORD SELECT
5 — TONE/WORD SELECT
6 — TONE/WORD SELECT
7 — TONE/WORD SELECT
8 — TONE/WORD SELECT
*Default Mode
CHART 1
Loading...