STI 9609-SS User Manual

8.25 in.(210mm)
STI-9610
6 in.(152mm)
8.25 in.(210mm)
1.5 in.(38mm)
3 in.(76mm)
5 in.(127mm)
STI-9601
STI-9601-SS
7 in.(178mm)
Safety Technology International, Inc.
2306 Airport Road • Waterford, Michigan 48327-1209 Phone: 248-673-9898 • Fax: 248-673-1246 Toll Free: 800-888-4784 • E-mail: info@sti-usa.com Web: www.sti-usa.com
2.75 in.(70mm)
8.25 in.(210mm)
5.75 in.(146mm)
STI-9602
7.125 in.(181mm)
1.5 in.(38mm)
4.25 in.(108mm)
Unit 49G Pipers Road • Park Farm Industrial Estate • Redditch
Worcestershire • B98 0HU • England • Tel: 44 (0) 1527 520 999 Fax: 44 (0) 1527 501 999 • Freephone: 0800 085 1678 (UK only) E-mail: info@sti-europe.com • Web: www.sti-europe.com
DRILL (4) .25 in.
6.3mm HOLES
19033 ANCHOR
(4) PROVIDED
STI-8170 BACKPLATE (OPTIONAL)
3.25 in.(83mm)
3 in.(76mm)
STI-9604
STI-9604-SS
8.25 in.(210mm)
4.6 in.(117mm)
3 in.(76mm)
3.9 in.(99mm)
STI-9605
STI-9605-SS
8.25 in.(210mm)
STI-9609
STI-9609-SS
3 in.(76mm)
IMPORTANT
STI-9610
Do not attempt to install the wire guard until the smoke sensor has been tested and in proper working order according to the manufacturer’s installation instructions furnished with the sensor unit.
INSTALLATION
1. Center the wire guard over existing smoke detector.
2. Mark and drill (4) mounting holes (see pictorial for size). Insert anchor into ceiling. NOTE: If lag shields and lag bolts are used, make sure anchor is flush with surface. Position guard, insert lag bolts and tighten. Length of bolt should be selected to assure full thread engagement in anchor.
3. STI-8170 BACKPLATE - STI recommends the use of this plate on all unstable mounting surfaces.
4. Insert screws through clamps and backplate (if used) and screw into anchors; but do not tighten.
5. Position guard over detector, slide clamps onto top wire of guard and tighten screws.
1.5 in.(38mm)
4.5 in.(114mm)
1.5 in.(38mm)
6 in.(152mm)
19020 CLAMP (4) PROVIDED
19013 SCREWS
#10 x 1 1/2 in.
(4) PROVIDED
SERVICE
1. Periodic cleaning of the smoke detector is required so dust and other matter do not accumulate.
2. To service the smoke sensor unit, loosen but do not remove the (4) screws rotate clamps and carefully remove wire guard.
OPTIONAL ACCESSORIES
1. SUB-82 - #8 x 1 1/2” spanner tamper resistant stainless steel screw kit.
2. 19038 - #8 spanner bit with 5/16” hex drive.
APPROVALS
STI-9601, STI-9602, STI-9604, STI-9605
UL Listed No. S3504 for use with Listed low profile smoke detectors
STI-9609, STI-9610
UL Listed No. S3504 for use with Listed high profile smoke detectors
Electronic warranty form at www.sti-usa.com/wc14
INSTALLATION OF STI CEILING MOUNTED SMOKE DETECTOR GUARDS
All specifications and information shown were current as of publication and are subject to change without notice.
9600 MARCH 2013
SMOKE DETECTOR COVERS
STI-9601 Low profile - Flush mount STI-9601-SS Low profile - Flush mount -
Stainless Steel STI-9602 Low profile - Surface mount STI-9604 Mini - Flush mount STI-9604-SS Mini - Flush mount -Stainless
Steel STI-9605 Mini - Surface mount STI-9605-SS Mini - Surface mount -
Stainless Steel STI-9609 High profile - Flush mount
STI-9609-SS High profile - Flush mount -
Stainless Steel STI-9610 High profile - Surface mount STI-9712 Photoelectric - Surface mount STI-9713 Photoelectric - Flush mount
BEAM SMOKE DETECTORS
STI-9623 For DS240 and DS241 STI-9624 For Fireray 50/100R STI-9625 For System Sensor Beam
Smoke Detector 6424 STI-9706 Flush Mount STI-9707 Surface Mount
PIR GUARDS
STI-9618 Corner Mount STI-9619 Corner Mount STI-9620 6.25 x 4 x 2.25” STI-9621 7 x 5.75 x 4.50” STI-9622 8.75 x 4 x 3.75”
CLOCK/BELL WIRE CAGES
STI-9631 10.5” Diameter STI-9631-SS 10.5” Diameter – Stainless Steel STI-9631-R 10.5” Diameter – Red STI-9632 16.5 Diameter STI-9632-SS 16.5 Diameter – Stainless Steel STI-9633 20” Diameter
EXIT SIGN WIRE CAGES
STI-9640 10.5 x 13.75 x 2.75” STI-9740 15.5 x 20.5 x 6”
BAY LIGHT WIRE CAGES
STI-9702 For Hubbell®Superbay Lights –
21.43 x 22.50”
STI-9709 For Hubbell®Superbay Lights – 24.5
x 26”
MISCELLANEOUS WIRE CAGES
STI-9601
STI-9625
STI-9796
STI-9632
STI-9640
STI-9702
STI-9649
STI-9705
STI-9624
STI-9618
STI-9651 Fluorescent Light Damage Stopper
®
STI-9705 Horn/Strobe/Speaker Damage Stopper®– Flush STI-9708 Horn/Strobe/Speaker Damage Stopper – Surface STI-9711 Horn/Strobe/Speaker Damage Stopper – Flush STI-9714 Horn/Strobe/Speaker Damage Stopper – Surface STI-9717 Speaker/Strobe Damage Stopper
®
– Flush
STI-9720 Speaker Strobe Damage Stopper
®
– Surface
STI-9730 Wire Guard Damager Stopper
®
STI-9796 Outdoor Light Damage Stopper
®
STI-9880 Fluorescent Lighting Damage Stopper®– Small STI-9881 Fluorescent Lighting Damage Stopper®– Large
MAY2011
ADDITIONAL WIRE GUARDS AVAILABLE
Visit www.sti-usa.com for complete details
STI • Waterford • MI • 800-888-4784
STI-9880
EMERGENCY LIGHT CAGES
STI-9641 10.7 x 14.6 x 4” STI-9644 8.7 x 17.7 x 5” STI-9645 13.8 x 21.7 x 5.9” STI-9649 10.75 x 24.75 x 11.25” STI-9703 5 x 13.5 x 4”
BEACON & SOUNDER CAGES
STI-9614 7.9 x 6” STI-9615 3.7 x 3.5” STI-9617 5.9 x 4.9” STI-9664 3.86 x 6.18” STI-9665 7 x 8.43”
STI-9604-SS
STI-9621
STI-9615
STI-9664
Loading...