Stego ETF 012 Catalog Page

AC
DC

REGULATING

18.02.2020 | Specifications are subject to change without notice. Suitability of this product for its intended use and any associated risks must be determined by the end customer/buyer in its final application.

ELECTRONIC HYGROTHERM WITH EXTERNAL SENSOR

ETF 012

81

81

> Efficient temperature

& humidity control

> Wide voltage range

> Operating temperature down to -40 °C
> High switching capacity
> With external sensor

The ETF 012 senses the ambient temperature and relative humidity in an enclosure. Depending on which contact
combination is chosen, it then turns on or off a connected device if either the temperature is below or the
humidity is above the set point. The integrated LED in each adjustment knob i lit when indicating the active function.
The external sensor can be positioned freely anywhere in the enclosure forprecise measurements.

TECHNICAL DATA

Switching difference (temperature) 2 K (±1 K tolerance) at +25 °C (+77 °F), 50 % RH

Switching difference (humidity) 4 % RH (±1 % tolerance) at +25 °C (+77 °F), 50 % RH

Reaction time (humidity) approx. 5 sec.

Contact type change-over contact (relay)

Service life VDE: NO/NC > 15,000 cycles

Max. switching capacity (relay output) 10 A resistive / 1.6 A inductive @ AC 240 V

Max. inrush current AC 30 A for 10 sec.

Connection 5-pole terminal, clamping torque 0.5 Nm max.:

Housing plastic, UL 94V-0, light grey

Mounting clip for 35 mm DIN rail, EN 60715

Mounting position vertical

Operating/Storage temperature -40 to +140 °F (-40 to +60 °C)

Operating/Storage humidity max. 90 % RH (non-condensing)

Dimensions 3.0 x 2.4 x 1.7" (77 x 60 x 43 mm)

Weight approx. 3.5 oz. (100 g)

Protection type IP20

Approvals UL File No. E164102, VDE, EAC

1

not UL confirmed

² When connecting with stranded wires, wire end ferrules must be used.

UL: NO/NC > 30,000 cycles

0.6 A @ DC 60 V¹

solid/stranded² wire – AWG 14 max. (2.5 mm²)

Hygrotherm

ETF 012

L N
+ –

Heater

Part No. Cable – 1 m Part no. Cable – 2 m Operating voltage Setting range – temperature Setting range – humidity

01231.0-00 01231.0-01 AC 100 – 240 V, 50/60 Hz (min. AC 90 V, max. AC 265 V) 0 to +60 °C 50 to 90 % RH

01231.9-00 01231.9-01 AC 100 – 240 V, 50/60 Hz (min. AC 90 V, max. AC 265 V) +32 to +140 °F 50 to 90 % RH

01231.1-00 01231.1-01 DC 24 – 48 V (min. DC 20 V, max. DC 60 V) 0 to +60 °C 50 to 90 % RH

Heater

Wiring example

N
L