Stego DA 084 Catalog Page

VENT PLUG

18.02.2020 | Specifications are subject to change without notice. Suitability of this product for its intended use and any associated risks must be determined by the end customer/buyer in its final application.

ACCESSORIES

101

101

DA 084 I

IP55

> High degree of protection (IP55) > Easy to install

It has become increasingly important to provide a protected enclosure environment for valuable and crucial
electrical and electronic components. In a tightly closed enclosure, pressure differentials can occur during extreme
temperature variations, such as day/night operation. When this occurs, the risk of dust and humidity ingression into
the control panel increases dramatically. The specially designed DA 084 vent plug permits a controlled change
in pressure and can easily be installed in any enclosure. The vent plug is suitable for the use in enclosures and
electrical cabinets in accordance with DIN EN 62208.

TECHNICAL DATA

Mounting PG 29 thread with union nut

Torque 5 Nm

Mounting position vertical

Material plastic, UL 94V-0, light grey

Sealing NBR gasket

Air Interface Approx. 1.5 cm²

Operating / Storage temperature -49 to +158 °F (-45 to +70 °C)

Dimensions Ø 2.58" x 1.2" (Ø 65.5 x 30.5 mm)

Approvals
Note Material adheres to limit values in accordance with RoHS3

1

Protection type is restricted to IP54 if mounting position is not vertical.

1

weather proof and UV light resistant according to UL746C (f1)

EAC

Installation
A hole with a diameter of 1.46" (37 mm) is required for mounting. Make sure that the sealing gasket is placed on the outer side
panel of the enclosure. For optimal pressure compensation, it is recommended to use two devices on opposite sides towards the
top of the enclosures.

Part No. Protection type Weight (approx.)

08400.9-01 IP55 1.1 oz. (31 g)