Page 1
Assembly Instruction Sheet
ToolsRequired: Flathead screwdriver, Phillips screwdriver,pliers, wire cutters, wire strippers,electrical tape, safety glasses.
LightSource:
EstimatedAssembly Time:
Preparation:
present.If any parts are missingordamaged, do not attempt toassemble, install, or operate thefixture. Contactcustomer service for replacement
parts.
Warnings and Cautions
Turn off electricity at circuit breaker or main fuse box before installation. Consult a licensed electrician if in doubt.
These instructions are provided for your safety. It is very important you read them completely before installing the fixture. We strongly
recommend that a licensed, professional electrician perform the installation.
Disconnect fixture from power source before replacing bulbs. Make sure bulbs are given sufficient time to cool before removal.
(1)A19 MediumBase Bulb100WMaximum or
(1)Medium Base Vintage bulbs are recommendedbutnot supplied.
30-45minutes
Identifyand inspect all parts beforebeginninginstallation. Check package content listand diagrams below to besureall parts are
Package Contents
C
Crossbar
A
x1
Shade
Mounting
Screw
B
x2
STEP 1 Install Crossbar and Fixture Body-
A. Pass the supply wires through the Crossbar (A). Attach the
Crossbar (A) to Outlet Box with the head of Green Ground Screw
facing you. Secure it with Outlet Box Screws (not included). Tighten
until snug.
B.RefertoStep2for
wiring connections.
C. Attach the Fixture
Body (C) over the
Crossbar (A) and
secure with Mounting
Screws (B). Tighten
until snug with
screwdrivers.
STEP 2 - Wire Connections
A. Use standard wire connectors (not included) to make all wire
Connections. Twist connectors until wires are tightly joined
together. Wrap each connection with approved electrical tape and
carefully stuff all the connected wires between Crossbar (A) and
White wire
from supply
Black wire from
supply (or Red)
Ground wire
from supply
Outlet
Box
Figure 1
Cap
D
x1
Supply Wires and
Ground Wire
A
Outlet Box Screw
(not supplied)
White wire
from fixture
Black wire
from fixture
Ground wire
from fixture
x1
E
B
Figure 2
Fixture
Body
x1
C
Installation Optional Shade
A. Remove Socket Collar from
Fixture Body (C).
B. Place Cap (D) over the
Socket, secure by threading
Socket Collar onto Socket.
Hand tighten until sung.
C. Insert bulb onto socket and
screw snugly into place.
D. Place the Optional Shade (E)
over the bulb and thread it
onto the Cap (D) properly.
Your fixture is now assembled
and ready to use. Enjoy!
Figure 4
FINISH: RUSTIC BLACK
C
Socket
D
Socket Csollar
Vintage Bulb
(recommended
but not supplied)
Optional
Shade
1”
4.75”
6.5”
11. 5 ”
6.5”
4.25” Dia.
6”
STEP 3 - Install Bulb
A. Insert bulb onto socket and
screw snugly into place.
Your fixture is now
assembled and ready to use.
Enjoy!
Figure 3
Socket
Vintage Bulb
(recommended
but not supplied)
NOTE: ALL DIMENSIONS ARE ROUNDED UP
TO THE NEAREST 1/4"
1of1
Loading...