Page 1
Assembly Instructions
DRESSER AND MIRROR ARE SOLD AND PACKED SEPARATELY
ASSEMBLY RATING
The Assembly Rating is a 5-point system that
shows the degree of effort needed in
assembling a specific product (with 1 being
easy and 5 being difficult). For some
products, two persons are recommended.
EASY
DIFFICULT
Page 1 of 4
Tools Required for Assembly:
Allen Wrench
2 PERSONS RECOMMENDED
(Included)
Rev.14-10-29
Page 2
Page 2 of 4
Page 3
MD
Before you begin, please read Page 2
of “Assembly and Care Advice”.
And remember, do not tighten until
each step is completed or instructed.
Parts List
#1 x 1 pc
Dresser
#2 x 1 pc
Mirror
#3 x 2 pcs
Support Rail
Hardware List
#A x 8 pcs
Bolt 1/4”x1-3/8”
#B x 8 pcs
Lock W asher
#C x 8 pcs
Flat W asher
#D x 1 pc
Allen Wrench
Due to the size and/or weight of this product, it is
highly recommended that the assembly should be
done near the area of its intended location. Make
sure you have enough space to move around during
the assembly. ALWAYS have at least two people to
help with transporting and assembling the product to
avoid any potential injury and/or damage, especially
with the fragile nature of the mirror .
Page 3 of 4
Page 4
With the help of another person, align the two support rails (#3)
vertically with the pre-drilled holes of the dresser (#1) and the
mirror (#2).
Turn right (clockwise) to tighten
#A x 8 pcs
#B x 8 pcs
#C x 8 pcs
I. Prepare 8 bolt assemblies
by inserting FIRST the lock
washer (#B) onto the bolt
(#A) and then the flat
washer (#C) onto the
SAME bolt (#A), in that
order.
II. Insert the bolt assemblies
through the 2 support rails
(#3) and secure those bolts
using an Allen wrench (#D)
to lock with the dresser (#1)
and the mirror (#2).
III. If needed, adjust the leveler
according to the ground
level. To lower or to raise
the center leg, turn the
leveler clockwise or
counterclockwise,
respectively.
ASSEMBLY IS COMPLETED
Page 4 of 4
Loading...