SteelFlex CLE-500 Owner's Manual
OWNER'S MANUAL
CLE-500
THERE IS A RISK ASSUMED BY INDIVIDUALS WHO USE THIS TYPE OF
EQUIPMENT. TO MINIMIZE RISK, YOU MUST FOLLOW THESE RULES:
1.Inspect equipment before each workout. Check that all nuts, bolts, screws and
pop pins are in place and fully tightened. Also, before use, check c ylinders for leaking.
Replace all worn parts immediately. Never use machine if any parts are
damaged or missing. Fallure to follow these rules may result in serious injury.
2.Keep clear of the cylind er and all moving parts when the machine is in use.
3.Exercise with care. Perform your exercises at a smooth moderate pace; never
perform jerky or uncoordinated movements that may cause injury.
4.It is recommended tha t you should workout with a training partner.
5.Do not allow children or minors to play on or around this equipment.
6.If unsure of proper use of equipment, call your local distri butor.
7.WARNING: Consult your physician before starting your exercise program. For your
own safety do not begin any exercise program without proper instruction.
The Surgeon General
has determined that lack
of physical activity is
detrimental to your health.
TM
Trademark of United States Fitness Produots Council
ASSEMBLY INSTRUCTIONS
Page
mm
inch
0
60
10
30
50
40
20
60 13012011010090
80
70
140
150
10
1"
6"
4"
3" 5"
2"
0
0
HARDWARE ILLUSTRATION
CLE-500
(A2)ROUND ALLEN HEAD M8x40L PARTIAL THREAD QTY.2
(A5)HEX BOLT M10X60L PARTIAL THREAD QTY.4
CLE500-032008
1.1
(A1)HEX BOLT M8X25L PARTIAL THREAD QTY.4
(A3)HEX BOLT M8X60L PARTIAL THREAD QTY.2
(A4)ROUND ALLEN HEAD M10x45L PARTIAL THREAD QTY.2
(A6)HEX BOLT M10X100L PARTIAL THREAD QTY.2
ASSEMBLY INSTRUCTIONS
Page
mm
inch
0
60
10
30
50
40
20
60 130120
110
10090
8070
140
150
10
1"
6"
4"
3"
5"
2"
0
0
CLE-500
CLE500-032008
1.2
(C1)3/8" ROUDN END CAP WASHER QTY.4
(B1)NYLON LOCK NUT M8 QTY.2
(B2)NYLON LOCK NUT M10 QTY.8
(C2)M8 SPRING WASHER QTY.6
(C3)M8(I.D.)FLAT WASHER Ø18X1.5T QTY.4
(C4)M8(I.D.)FLAT WASHER Ø24X1.5T QTY.6
(C7)M10(I.D.)FLAT WASHER Ø27X2T QTY.4
(C8)1/2" BOLT CAP(9212-024) QTY.4
HARDWARE ILLUSTRATION
(C5)M10(I.D.)FLAT WASHER Ø19X2T QTY.4
(C6)M10(I.D.)FLAT WASHER Ø25X2T QTY.4
Loading...