SteelFlex CEO-200 Owner's Manual

OWNER'S MANUAL

CEO-200

THERE IS A RISK ASSUMED BY INDIVIDUALS WHO USE THIS TYPE OF
EQUIPMENT. TO MINIMIZE RISK, YOU MUST FOLLOW THESE RULES:

1.Inspect equipment before each workout. Check that all nuts, bolts, screws and
pop pins are in place and fully tigh tened. Also, before use, check cylinders for leaking.
Replace all worn parts immediately. Never use machine if any parts are
damaged or missing. Fallure to fol lo w these rules may result in serious injury.

2.Keep clear of the cylinder and all moving parts when the machine is in use.

3.Exercise with care. Perfor m your exercises at a smooth moderat e pace; ne ver
perform jerky or uncoordi nated movements that may cause injury.

4.It is recommended that you s hould workout with a training partne r .

5.Do not allow children or minors to play on or around this equipment.

6.If unsure of proper use of equipment, call your local distributor.

7.WARNING: Consult your physician before starting your exercise program. For your
own safety do not begin any exercise program without proper instruction.

The Surgeon General

has determined that lack

of physical activity is

detrimental to your health.

TM

Trademark of United States Fitness Produots Council

ASSEMBLY INSTRUCTIONS

Page

CEO-200

HARDWARE ILLUSTRATION

1.1

(A2)ROUND INNER HEX SCREW M8X40L PARTIAL QTY.4

CEO200-032008

2

1

3

4

5

6

(A4)BOLT CAP(9212-024) QTY.8

(A1)ROUND INNER HEX SCREW M8X45L PARTIAL QTY.2

(A3)HEX BOLT M12X130L PARTIAL QTY.4

(A5)M10X25L SOCKER FLAT SCREW QTY.1

ASSEMBLY INSTRUCTIONS

Page

CEO-200

HARDWARE ILLUSTRATION

1.2

(B1) M8 NYLON LOCK NUT QTY.2

CEO200-032008

(B2)M10 NYLON LOCK NUT QTY.2

2

1

3

4

5

6

(C1)M8(I.D.)FLAT WASHER Ø24 QTY.4

(C2)M10(I.D.)FLAT WASHER Ø27 QTY.2

(C3)1/2" ROUND END CAP WASHER QTY.8

(C4)M10 SPRING WASHER QTY.2

(B2)M12 NYLON LOCK NUT QTY.4