Steelcraft Automotive 53020 User Manual
GRILL GUARD
00-02 TOYOTA TUNDRA
PARTS LIST
1- FRONT BAR 1- TOP BRACKET
2-FRAME BRACKETS 4-M12*50 HEX BOLTS
6-M10*30 HEX BOLTS 2-M12*80 HEX BOLTS
6-M10 LOCK NUTS 4-Φ12 FLAT WASHERS
12-Φ10*34*3 SUPER LARGE WASHERS 4-Φ12 SPLIT WASHERS
3-M6*20 HEX BOLTS
6-Φ6 FLAT WASHERS
3-Φ6 SPLIT WASHERS
Remove factory tow hooks from front section of vehicle
Using the factory tow hook bolts, attach the frame brackets as shown in the diagram. Handtighten bolts in case you have to adjust the front bar to align it.
Attach front bar to inside of the frame using the 7/16 x ¼ hex bolts, nuts, and flat washers. Do
not tighten until the front bar is aligned with the front of the vehicle.
The top bracket is attached to the hood latch support just inside the grill. Open the hood and it
will expose the hood latch bracket. There are two factory holes in the hood brackets.
Place the top bracket under the hood latch support and line up the two holes. Use the bolts
provided to hold the top bracket in place.
Line up the hole in the back of the grill guard center plate with the hole in the front of the top
bracket and install and tighten the third supplied bolt.
Once guard is aligned on vehicle, tighten all remaining bolts.
Page 1 of 1
Loading...