Steelcraft Automotive 34110 User Manual

STEELCRAFT

INSTALLATION INSTRUCTIONS

TAILLIGHT GUARD PART # T7766

2005 NISSAN FORNTIER

PARTS LIST
(1)- TAILLIGHT GUARD PASSENGER SIDE
(1)- TAILLIGHT GUARD DRIVER SIDE
(2)- SUPPORT BRACKETS
(2)- # 6 x 1/2" SCREWS, (2)- 1/4 SCREWS, (2)- 1/4 WASHERS

INSTALLING TAILLIGHT GUARD

1) START WITH THE PASSENGER SIDE, OPEN THE REAR GATE AND REMOVE THE SCREWS SECURING THE

TAIL LIGHT TO THE BODY.

2) CAREFULLY UNSNAP THE TAIL LIGHT UNTIL IT IS FREED FROM THE HOUSING.

3) ATTACH THE SUPPORT BRACKET TO THE EXISTING HOLE BY USING THE 1/4 x 3/4” SCREW, 1/4 WASHER

AND 1/4 HEX NUT.

4) SNAP THE TAIL LIGHT ASSEMBLY BACK INTO BODY.

5) POSITION REAR TAILLIGHT GUARD OVER TAIL LIGHT, MAKING SURE THAT THE MOUNTING BRACKETS

ON THE TAILLIGHT GUARD ARE SEATED WHERE THE TAIL LIGHT SCREWS WERE FORMERLY LOCATED.

6) SECURE ASSEMBLY TO JAMB USING THE EXISTING SCREWS. SUPPORT BRACKET USE THE # 6 x 1/2”
SCREWS.

7) RE-PEAT STEPS 1 THROUGH 6 ON THE DRIVER SIDE.

CUSTOMER SERVICE TOLL FREE (888) 800-ARIES