Steelcraft Automotive 140930 User Manual

VIEWPOINT ALUMINUM RUNNING BOARD

1

Driver/ Left Running Board

12

8mm Hex Nuts

1

Passenger/Right Running Board

12

6mm “T” Bolts

6

Mounting Brackets

12

6mm x 22mm OD x 2mm Large Flat Washers

12

8mm x 24mm x 2mm Flat Washers

12

6mm Lock Washers

12

8mm Lock Washers

12

6mm Hex Nuts

Passenger/Right
Running Board

Driver/Left
Running Board

(6) Mounting Brackets
Front

2005-12 NISSAN PATHFINDER

Parts List:

PROCEDURE:

1. REMOVE CONTENTS FROM BOX. VERIFY ALL PARTS ARE PRESENT. READ
INSTRUCTIONS CAREFULLY.

2. Locate the threaded studs on the inner body panel, (Figure 1). Select (1) Mounting Bracket

and hang it from the front mounting location, (Figures 2 & 3). Secure it with the included (2)
8mm Flat Washers, (2) 8mm Lock Washers and (2) 8mm Hex Nuts. Snug hardware but do not
tighten at this time.

3. Repeat Step 2 for the driver side Center and Rear Mounting Bracket installation, (Figures 2 &

3).

4. Select the driver/left side Running Board. Locate the openings cut at the end of the slots on the

bottom of the Running Board, (Figure 4). Insert (3) 6mm T-Bolts into each channel through the
openings. Slide the T-Bolts into the approximate position in line with the (3) Brackets.

5. Carefully place the Running Board in position on top of the Brackets. Slide the T-Bolts forward
or back until they line up and drop into the slots on the Brackets. Secure the Running Board to
the Brackets with (6) 6mm Flat Washers, (6) 6mm Lock Washers and (6) 6mm Hex Nuts,

(Figure 5). Do not tighten hardware at this time.

6. Adjust and level the Running Board and tighten all hardware.

7. Repeat Steps 2 - 6 for passenger Running Board installation.

8. Do periodic inspections to the installation to make sure that all hardware is secure and tight.

To protect your investment, wax this product after installing. Regular waxing is recommended to add a

protective layer over the finish. Do not use any type of polish or wax that may contain abrasives that could
damage the finish.
For stainless steel: Aluminum polish may be used to polish small scratches and scuffs on the finish. Mild
soap may be used also to clean the Running Board.

Page 1 of 2 9/5/12 (DP)

(Fig 1) Locate factory mounting locations

Fig 3

Fig 4

Slide 6mm T-Bolts into slots
at end of Running Board

Rear

(2) 8mm Flat Washers
(2) 8mm Lock Washers
(2) 8mm Hex Nuts

Fig 2

Complete Installation

Fig 4

(2) 8mm Flat Washers
(2) 8mm Lock Washers
(2) 8mm Hex Nuts

(2) 6mm T-Bolts
(2) 6mm Flat Washers
(2) 6mm Lock Washers
(2) 6mm Hex Nuts

Page 2 of 2 9/5/12 (DP)

VIEWPOINT ALUMINUM RUNNING BOARD

2005-12 NISSAN PATHFINDER

Driver Side Installation Pictured