Steelcraft AX633-TS, Terrain Series Manual
TERRAIN
3 WHEEL TRAVEL SYSTEM STROLLER
www.britax.com.au
Series AX633-TS
Suitable for use with the Safe n Sound Unity Baby Capsule
(Baby Capsule sold separately)
IMPORTANT: KEEP THIS BOOKLET IN A SAFE PLACE FOR FUTURE REFERENCE.
02
ALWAYS FOLLOW THE MANUFACTURERS INSTRUCTIONS.
READ ALL INSTRUCTIONS CAREFULLY BEFORE ASSEMBLY AND USE
OF THIS STROLLER.
THE CORRECT USE AND MAINTENANCE OF THIS PRODUCT IS
ESSENTIAL.
• USE GREAT CARE WHEN USING THE STROLLER ON STAIRS,
ESCALATORS, TRAVELATORS OR OTHER MOVING SURFACES.
• IT IS RECOMMENDED TO REMOVE THE CHILD FROM THE STROLLER
BEFORE GOING UP OR DOWN STAIRS OR ESCALATORS.
• DO NOT LIFT THE STROLLER BY THE ARM BAR BECAUSE IT MAY
DISENGAGE.
• DO NOT ALLOW CHILDREN TO STAND ON THE SEAT.
• DO NOT HANG BAGS OR GOODS FROM THE HANDLE AS THIS
COULD CAUSE THE STROLLER TO TIP OVER.
• DO NOT LEAVE THE STROLLER AND ITS ACCESSORIES NEAR AN
OPEN FIRE OR EXPOSED FLAME.
• DO NOT PLACE MORE THAN 4KG IN THE BASKET, OR 1KG IN THE
CANOPY POCKET (IF SUPPLIED).
IMPORTANT NOTES:
IMPORTANT NOTES
03
WARNINGS: TO AVOID INJURY OR DEATH:
ALWAYS APPLY THE BRAKES WHENEVER THE STROLLER IS
STATIONARY.
• DO NOT LEAVE CHILDREN UNATTENDED.
• SECURE THE CHILD IN THE HARNESS AT ALL TIMES.
• DO NOT CARRY EXTRA CHILDREN OR BAGS ON THIS STROLLER.
• MAKE SURE CHILDREN ARE CLEAR OF ANY MOVING PARTS IF YOU
ADJUST THE STROLLER.
• DO NOT USE ANY ACCESSORIES OTHER THAN THOSE APPROVED
FOR USE WITH THIS STROLLER BY BRITAX.
• IT IS UNSAFE TO USE ACCESSORIES NOT APPROVED FOR USE WITH
THIS STROLLER.
• THE MAXIMUM WEIGHT OF THE CHILD USING THIS STROLLER IS
NOT TO EXCEED 17 KG.
This CAUTION Symbol is shown at certain steps in
this Instruction Manual to highlight the danger
of being injured by moving parts.
CAUTION
FOR IMPORTANT NOTES AND WARNINGS ON ACCESSORIES REFER TO THEIR INDIVIDUAL SECTIONS IN THIS BOOK.
THE MAXIMUM WEIGHT VARIES FOR EACH ACCESSORY.
WARNINGS
04
The SMART lifting technique
This technique can be used to pick up small light loads from low levels.
Size up the Load
• Assess the load (size, shape and weight).
• Assess whether the load needs to be moved;
• Where is it going to be placed” Check that there are no obstructions;
• Assess whether mechanical or human assistance is required.
Move the Load as close to the body as possible
• A load is heavier to lift or carry if it is not close to the body.
• The whole hand should be used to ensure a rm grip.
Always bend your knees
• Maintain balance.
• Keep feet apart and in a comfortable position.
• Minimise lower back bending.
• Bend knees preferable at as large an angle as possible but not at a right
angle - use a semi squat in preference to a full squat.
Raise the load with your legs
• Achieve the lift smoothly and without jerkiness.
• Maintain the normal curvature of the spine to allow the force of the
load to be distributed evenly from the spine to the pelvis.
Turn your feet in the direction that you want to move the load.
• Avoid unnecessary bending, twisting and reaching.
• Change direction by turning your feet and not your back.
• To set the load down, squat down, keep your head up and let your legs
do the work.
Remember to ‘THINK TALL’ chest lifted, shoulders relaxed, chin
tucked in and head level.
MANUAL HANDLING TECHNIQUES
05
A 1 x Stroller Frame,
Seats & Basket
B 1 x Canopy
C 1 x Front Wheel
D 2 x Rear Wheels
E 1 x Rear Wheel Assembly
PARTS LIST
F 2 x Locking Clip
06
PARTS LIST
G 1 x Head Snuggler
B 1 x Bootcover
C 2 x Shoulder Pads
E 1 x Rain Cover
07
IMPORTANT NOTES:
PLEASE REFER TO PAGE 4 FOR SMART LIFTING TECHNIQUES.
• RELEASE THE STORAGE LATCH WITH DUE CARE AND OPEN THE FRAME.
• WHEN OPENING THE STROLLER, BE AWARE OF THE DANGER OF BEING
INJURED BY MOVING PARTS AND LOCKING DEVICES DURING TH
PROCESS. KEEP ALL HANDS AND LIMBS CLEAR OF THESE PARTS.
• THERE IS POTENTIAL FOR FINGERS OR PARTS OF THE BODY TO BE
INJURED WHEN THE STROLLER IS BEING UNFOLDED, DUE CARE
SHOULD BE EXERCISED.
• KEEP CHILDREN CLEAR OF THE STROLLER WHEN UNFOLDING THE
STROLLER.
• OPEN THE STROLLER SLOWLY AND BE CAREFUL WHERE YOU PLACE
YOUR HANDS.
STROLLER ASSEMBLY
OPENING THE STROLLER FRAME
08
STROLLER ASSEMBLY
OPENING THE STROLLER FRAME
A Lay the stroller frame down at and release the frame lock.
B To open the frame, lift the handles upwards until the stroller frame
extends and locks into position. Push down on the handle to conrm
the frame is locked.
09
STROLLER ASSEMBLY
INSTALLING THE REAR WHEEL ASSEMBLY
NOTE: Tip the frame over to install the rear wheel assembly.
A To attach the rear wheels, push in the wheel lock button and then
push the rear wheel onto the axle of the assembly and release the
wheel lock button. Pull on the wheel to ensure it is locked on.
Wheel
Lock
Button
STROLLER ASSEMBLY
10
INSTALLING THE REAR WHEEL ASSEMBLY
B Lower the rear wheel assembly onto the rear legs of the stroller frame
and insert the two plastic locking clips into rear legs of the stroller
frame. Pull on the rear wheel assembly to ensure it is correctly
installed.
Plastic
Locking
Clips
CAUTION
11
STROLLER ASSEMBLY
INSTALLING THE FRONT WHEEL
A Remove the plastic protector (where tted) from the front forks. Push
the front wheel axle fully into the wheel forks.
B Place the securing washer on both sides, ensure the tabs in the
washers are located into the circular holes just above stroller frame.
12
STROLLER ASSEMBLY
INSTALLING THE FRONT WHEEL
C Tighten the front wheel axle by turning the quick release hub in a
clockwise rotation and push the lever in to lock.
13
STROLLER OPERATION
USING THE FRONT SWIVEL WHEEL
WARNING: THIS PRODUCT IS NOT INTENDED FOR
JOGGING. DO NOT RUN WHILE USING THIS PRODUCT.
A To allow the front wheel to swivel for greater mobility, rotate the knob
clockwise until the rivet in the knob faces forward.
B To lock the swivel wheel, rotate the knob clockwise half a turn and
move the fork until it locks into position.
Note: Pneumatic front and rear tyres can be inated with a bicycle
pump at a garage pump and they have a maximum ination pressure
of 2.4 bar(35 p.s.i).
RIVET
14
STROLLER OPERATION
USING THE BRAKES
WARNING: ALWAYS APPLY THE BRAKES WHEN THE
STROLLER IS STATIONARY.
A To lock the brakes, push down on the brake lever using your foot.
B To release the brakes, lift the brake lever using your foot.
A
B
Loading...