Steamfast SF-294 Owner's Manual
3-in-1 Steam Mop
Balai à vapeur 3-en-1
Trapeador a Vapor 3-en-1
Owner’s Guide
Mode d’emploi
Guía del Usuario
MODEL SF-294
MODÉLE SF-294
MODELO SF-294
ENGLISH p. 2
FRANÇAIS p. 20
ESPAÑOL p. 38
KEEP YOUR RECEIPT FOR
WARRANTY PURPOSES
Please read all instructions before use.
GARDEZ VOTRE REÇU AUX
FINS DE LA GARANTIE
Veuillez lire toutes les instructions avant l’utilisation.
GUARDE SU RECIBO A EFECTOS
DE LA GARANTÍA
Lea todas las instrucciones antes de usarlo.
IMPORTANT SAFETY INSTRUCTIONS
READ ALL INSTRUCTIONS BEFORE USE
DANGER
Any appliance is electrically live even when switched off. To reduce risk of electrical shock:
1. Always unplug power cord immediately after using.
2. Do not place or store unit where it can fall or be pulled into a sink or tub.
3. Do not place in, or drop into water or other liquid.
4. If unit falls into water, immediately unplug power cord. Do not reach into the water.
WARNING
To reduce risk of burns, electrocution, re, or injury to persons:
1. Use 3-in-1 Steam Mop only for its intended purpose as indicated in this manual.
2. If an extension cord is necessary, use a properly rated cord (15 ampere, 14 gauge). Use care
to position extension cord where it is least likely to be damaged or tripped over during use.
3. Before plugging power cord into electrical outlet, be sure that all electrical information on rating
label agrees with your power supply.
4. To reduce likelihood of circuit overload, DO NOT operate another high wattage appliance on
the same circuit as this unit.
5. To protect against risk of electrical shock, do not immerse unit in water or other liquids. Do not
use power cord as handle, let it hang over edges of counters, or be crimped or closed in doors.
6. Never yank power cord to disconnect from outlet; instead, grasp plug and pull to disconnect.
7. Do not operate unit with a damaged power cord or if the unit has been dropped or damaged.
To avoid risk of electrical shock, do not disassemble unit; contact Steamfast Consumer Service
for examination and repair. Incorrect reassembly can cause a risk of electrical shock when unit
is used.
8. Close supervision is required for any appliance being used near children, pets and plants. Do
not leave unit unattended while plugged in.
9. This unit is not intended for use by persons (including children) with reduced physical, sensory
or mental capabilities, or lack of experience and knowledge, unless they have been given
supervision or instruction concerning use of the unit by a person responsible for their safety.
WARNING: To reduce risk of re, electrical shock or injury, the following basic
safety precautions should always be followed when using an electrical
appliance.
WARNING: To reduce the risk of electrical shock, this appliance uses a
grounded (three-pronged) plug. This plug will t in a grounded wall outlet
only one way. If the plug does not correctly t in the outlet, contact a licensed
electrician to install a proper outlet. DO NOT attempt to modify the plug or
defeat this safety feature.
2 | ENGLISH
10. Do not use unit where aerosol-based products are being used, or where oxygen is being
administered.
11. Unit is only meant to be used with recommended SF-294 3-in-1 Steam Mop accessories.
Using other types of attachments may cause damage to unit or injury.
12. If Power Indicator Light does not illuminate when Steam Control Dial is turned past “OFF”
setting, unit is not operating normally. Immediately turn unit off and disconnect from power
supply – have unit serviced by qualied service personnel.
13. When lling Water Tank, only water should be used in unit – other cleaning agents could
damage unit or cause injury. Distilled or de-mineralized water is highly recommended, in
order to minimize potential build-up of mineral deposits. Do not overll unit.
14. Do not attempt to use unit without properly lling Water Tank.
15. To reduce risk of contact with hot water emitting from Steam Nozzle, check appliance before
each use by positioning it away from body and turning it on. Do not operate unit if Steam
Nozzle is blocked.
16. Burns can occur from touching hot metal parts, hot water, or steam. Do not touch Steam
Nozzle or attempt to connect accessories while unit is in use. Use caution when you turn unit
upside-down – there may be hot water in unit.
17. Use caution when using unit on uneven surfaces, such as stairs.
18. When steaming any surface for the rst time, it is recommended that you consult the
manufacturer’s guidelines for material being steamed. For items in question, test on a small
inconspicuous area before proceeding.
19. Steaming unsealed hardwood or unglazed ceramic surfaces is not recommended, and may
result in warping or damage to the surface. Steam may remove the sheen from surfaces
treated with wax.
20. When steam mopping, never leave unit resting in one spot on any surface for any period of
time – prolonged exposure to heat and moisture may damage oor surfaces.
21. Do not allow power cord to touch hot surfaces during use. Wrap cord loosely around Cord
Brackets when storing.
22. Always allow 3-in-1 Steam Mop to cool completely (at least 30 minutes) and empty Water
Tank before storing. Do not store unit with a damp Microber Pad still attached.
SAVE THESE INSTRUCTIONS!
FOR HOUSEHOLD USE ONLY
Questions or comments?
•
www.steamfast.com
•
consumerservice@steamfast.com
•
1-800-711-6617
ENGLISH | 3
The following features and accessories are included with your 3-in-1 Steam Mop. Carefully
inspect the packing material for all parts listed below. To obtain possible missing parts, refer to
Product Support on Pages 17 & 18 of this manual.
UNIT FEATURES
& ACCESSORIES
Steam Nozzle
Water Tank
Water Tank Cap
Water Tank Fill Hole
Power Indicator Light
Steam Control Dial
Extension Pole
Handle
Cord Brackets
Mop Head
Microber Pads (2)
Utility Brushes (3)
Jet Nozzle
Fabric Nozzle
Squeegee
Measuring Cup
Cleaning Pin
1
2
2a
2b
3
4
5
5a
5b
6
7
8
9
10
11
12
13
Product Information
4 | ENGLISH
•
The Steam Nozzle (1) emits the ow of hot, penetrating steam. The Mop Head, Jet Nozzle and
Fabric Nozzle all connect to the Steam Nozzle.
•
The Water Tank (2) is the translucent reservoir where water is held before being transferred to
the heat exchange and converted to steam. The Water Tank holds 15 oz. (450 ml.) of water.
•
The Water Tank Cap (2A) covers the Water Tank Fill Hole, and must be removed in order to ll
the Water Tank with water.
•
The Water Tank Fill Hole (2B) is the opening through which water is poured into the Water Tank.
•
The Power Indicator Light (3) illuminates when the Steam Control Dial is set from “OFF” to any
of the steam intensity settings, to indicate that the unit is powered on and heating.
•
The Steam Control Dial (4) is used to set desired steam intensity, as well as turn the unit
on and off.
•
The Extension Pole (5) connects to the main body of the unit, and is designed for convenient
use on oors, windows, and other out-of-reach surfaces.
•
The Handle (5A) provides a comfortable grip when using the Extension Pole.
•
The Cord Brackets (5B) provide a safe and convenient way to store the power cord when not in use.
•
The Mop Head (6) connects to the Steam Nozzle, for steam cleaning a variety of hard oors.
NOTE: It is NOT recommended that this unit be used on unsealed oors. Use care when
steaming oors that may be warped or damaged by heat and moisture, and limit use of
this unit on these types of surfaces.
•
The Microber Pads (7) each attach to the pad grips on the bottom of the Mop Head. The
Pads are designed to clean scuffs and stains from hard oors. The Microber Pads are reusable
and machine washable. Two Pads are included.
NOTE: Microber Pads are not designed to absorb and collect large amounts of dirt.
For best results, it is recommended to vacuum oor before mopping.
•
The 3 Utility Brushes (8) connect to the Jet Nozzle, and are designed for scrubbing tough
stains. There is a soft bristle Brush for scrubbing delicate items (such as children’s toys), a
hard nylon Brush for general scrubbing (such as carpet), and a brass-bristled Brush for
scrubbing metal surfaces (such as oven and grill racks).
NOTE: Use careful judgement when deciding what surface to clean with the brass Utility
Brush. Some delicate surfaces, such as stainless steel, may be scratched or damaged
by the brass bristles. If you are unsure whether or not a surface will be damaged, it is
recommended that you test a small inconspicuous spot before proceeding.
•
The Jet Nozzle (9) connects to the Steam Nozzle, and is designed to focus the ow of steam for
concentrated cleaning.
•
The Fabric Nozzle (10) connects to the Steam Nozzle, and is designed to disperse the ow of
steam for steaming fabrics, linens and upholstery. The Fabric Nozzle also serves as an adapter
for connecting the Squeegee.
•
The Squeegee (11) connects to the Fabric Nozzle, and is used for cleaning windows, mirrors,
and other smooth glass surfaces.
•
The Measuring Cup (12) is used to easily ll the Water Tank with water.
•
The Cleaning Pin (13) is used to remove mineral deposits that may form in the opening of the
Steam Nozzle and the attachments.
ENGLISH | 5
STEAM MOP SETUP
EXTENSION POLE
1. Insert threaded connector on bottom of Extension Pole into pole base on main unit
(FIGURE 1-A).
2. Rotate Extension Pole in a clockwise direction as shown to screw it into pole base
(FIGURE 1-B). Make sure Pole is tightly secured to main unit.
3. To adjust length of Extension Pole:
A) Rotate upper (thicker) section of Extension Pole in “UNLOCK” direction indicated on label to
unlock it (FIGURE 1-C).
B) Adjust upper section to desired length (FIGURE 1-D).
C) Rotate upper section of Extension Pole in “LOCK” direction indicated on label to lock it back
in place (FIGURE 1-E).
NOTE: Increasing length of Extension Pole may provide additional leverage for easier,
more effective steam mopping.
Assembling Your
3-in-1 Steam Mop
A
B
THREADED
CONNECTOR
UPPER SECTION
POLE
BASE
D EC
FIGURE 1
6 | ENGLISH
Loading...