Steamaster POLIVAC PREDATOR MKII, POLIVAC PREDATOR MKIII Operations Manual & Trouble Shooting Manual

1

POLIVAC PREDATOR MKII

OPERATIONS MANUAL & TROUBLE SHOOTING GUIDE

Steamaster | 6 Reservoir Avenue Greenacre Sydney NSW 2190 Australia | Tel: [phone] | Tel: [phone] | Fax: [phone] | www.steamaster.com.au

2

This is an introduction on the use of the Polivac Predator Carpet Extractor unit.

DIRECTIONS FOR USE

1. Connect 240v extension cable from power source to #1 power socket on unit. Fig #1

2. Now connect the Male end of solution hose to Female solution outlet on the

front of the unit. Fig #2

3. Connect the Female solution end to the Male fitting on the trigger of the

steam cleaning wand.

4. Ensure dump valve and booster inlet are closed, if these are not in use. Fig # 3 & 4

5. Fill machine with either cold or hot water. We always recommend pre-spraying the carpet

rather than use of Chemical solutions and powders run through the machine, for a number
of reasons, 1st this gives better results as the chemical has had time to “work” on the
carpets, 2nd when you extract with fresh water, you remove more chemical residue which
prevents re-soiling and chemical build up. Finally it extends the life of your pump, the use of
high alkaline chemicals can cause premature failure not covered by warranty. NEVER USE
FLAMABLE LIQUIDS OR SOLVENTS IN THE STEAMCLEANER

Fig #1

6. The heater switch can now be selected and as power is connected the switch

will light up RED and this will commence the heater working. `

7. Water is now being heated up.

8. Connect the vac hose to the domes nose and the other end to the wand end.

You are now ready to clean!!

Steamaster | 6 Reservoir Avenue Greenacre Sydney NSW 2190 Australia | Tel: [phone] | Tel: [phone] | Fax: [phone] | www.steamaster.com.au

How to Use Your Polivac Predator MKII

Click on The Video to Watch Now

3

Steamaster | 6 Reservoir Avenue Greenacre Sydney NSW 2190 Australia | Tel: [phone] | Tel: [phone] | Fax: [phone] | www.steamaster.com.au