St. Bernard iPrism 3000 User Manual

The iPrism Model 3000 System

Page 1

Hardware Reference

On/Off Switch

HDD LEDPOWER LED

Reset Switch

Figure 1. Model 3000 Front Panel (with cover open)

• On/Off Switch: When power is not applied to the system, press this switch to power the iPrism.

When power is on you should use the Appliance Manager to shut down your system. If it is not
possible, then pressing this switch once will tell the iPrism to perform an orderly shut down after
which it will power down the iPrism. If the system does not shut down after about five minutes,
holding the power switch for 5 seconds will power down the iPrism instantly, although this may
result in the loss of the last few minutes of logging data.

• Reset Switch: Press once to preform a reset of the iPrism. This switch should be used as a last

resort. The preferred method to reset your iPrism is to start the Appliance Manager, go to the
Exit section and select the Reboot option.

• POWER LED: This LED indicator illuminates when power is applied to the system.

• HDD LED: Indicates disk activity.

Page 2