State Industries SCGSS01108 User Manual
COMMERCIAL
™
FORCE 90+
96% Efficient
Power Direct-Vent Commercial Gas Water Heater
The 100,000 BTU Force 90+™light-duty commercial gas water heater is equipped with a fully submerged, spiral-shaped condensing heat exchanger and 50 gallons of storage capacity. This design provides much greater heat transfer surface than a standard straight flue tube, resulting in
96% thermal efficiency and higher hot water output than comparable 80% efficient water heaters. With a 22˝ diameter, the Force 90+™ can be
installed in less space than a 75-gallon unit yet delivers greater recovery and lower operating costs.
Power Direct-Vent Design for Installation Versatility
• Modular blower, with 120V, 60Hz electrical system (5 amps or less)
• Combined horizontal and vertical vent runs terminating through outside wall,
using Schedule 40 PVC pipe as follows:
2˝ pipe allows vent runs up to 20 equivalent feet
3˝ pipe allows vent runs up to 60 equivalent feet
4˝ pipe allows vent runs up to 120 equivalent feet
Available in Natural Gas or Propane
Side-Mounted Taps for Recirculating Systems
• Hot and cold “side taps” allow the Force 90+™ to be used for “combination” systems
for water heating plus space heating, radiant floor heating or other applications
requiring a recirculating hot water loop
• Plugs for recirculating taps are factory installed
Advanced Electronic Control
• Large LCD display
• Precise temperature control
• Advanced diagnostics
Glass Lined Tank with Two Magnesium Anode Rods
• Provides superior protection against corrosion
• Commercial-grade glass lining protects all “water side” tank surfaces plus inside of internal
heat exchanger exposed to condensate
Top-Fired Low-NOx Burner
• Reduces NOx emissions up to 33%, complies with Southern California and
Texas requirements
Factory-Installed Temperature and Pressure Relief Valve
Maximum Hydrostatic Working Pressure: 150 psi
Meets ASHRAE/IESNA 90.1 (latest standard)
• Design-certified by UL (Underwriters Laboratories) according to
ANSI Z21.10.3-CSA4.3 standards governing storage-type water heaters
Three-Year Limited Tank Warranty
• Consult written warranty shipped with water heater or contact State for complete
warranty information
™
FORCE 90+
96% Efficient
Power Direct-Vent Commercial Gas Water Heater
SPECIFICATIONS
BTU
MODEL
NUMBER
SHE50 100NE 100,000 50 291 116 83 255
Manifold Pressure: 4.0 inches w.c. (.99 kPa); All models–Maximum Supply Pressure: 14 inches w.c. (3.48 kPa) Minimum Supply Pressure Natural Gas: 3.5 inches w.c.
(.87 kPa). Minimum Pressure Propane: 8.0 inches w.c. (1.99 kPa). Minimum Pressure must be maintained under both load and no-load (static and dynamic)
conditions.
INPUT
PER
HOUR
TANK
SIZE
GALLONS
40ºF 100ºF 140ºF
RECOVERY–GALLONS
PER HOUR
AT DEGREE RISE
SHIPPING
WEIGHT
LBS.
DIMENSIONS
SHE50 100NE A B C D E F
INCHES 68-1/2 49-1/4 22 15-3/4 3 8
Top inlet and outlet: 3/4˝ male NPT
Side inlet and outlet: 3/4˝ female NPT
Gas inlet: 1/2˝ NPT
Optional Concentric Vent Kit Part # 9003910105
SUGGESTED SPECIFICATION
(Natural or Propane) gas water heater(s) shall be State Force 90+™ model # SHE50 100NE, with 96% thermal efficiency, a storage capacity of 50 gallons, an input rating of 100,000 BTU per hour, a recovery
rating of 116 gallons per hour at 100ºF rise and a maximum hydrostatic working pressure of 150 psi. Water heater(s) shall be of power direct-vent design, using 2˝, 3˝ or 4˝ PVC pipe for horizontal and/or vertical
vent runs. Water heater(s) shall have: 1: Seamless, glass lined steel tank construction and a spiral-shaped heat exchanger placed entirely inside the tank, which shall be glass lined on the flue gas side to protect
against acidic condensate. 2: Advanced electronic control with large LCD display and advanced diagnostics. 3: A 3-year limited warranty against tank leaks. Water heater(s) shall meet or exceed ASHRAE/IESNA
90.1 (latest revision), and be design-certified by UL (Underwriters Laboratories) according to ANSI Z21.10.3-CSA4.3 standards governing storage tank water heaters.
For complete information on limited warranties, consult written warranty
or contact the State Customer Care Center at 1-800-365-0024.
State Industries, Inc. reserves the right to make product changes or improvements without prior notice.
For more information on State Water Heaters, contact:
State Water Heaters
500 Tennessee Waltz Parkway
Ashland City, TN 37015
800-365-0024 Toll-free USA
www.statewaterheaters.com
SCGSS01108
Loading...