STARVILLE MATRIXX TLB-20 DMX User Manual

User Manual

Please read this Manual assiduous before start working

with the effect light!!!

2



Packing List

1 pcs. Stairville maTRIXX TLB-20 DMX
1 pcs. Power cord
1 pcs. Owners manual
2 pcs. Lighting Hangers



Product Introduction：



This product adopts the latest appearance, with small volume, light
heaviness, nice appearance and good heat scattering. The luminary
constitutes of 64 LED light pearls with high brightness, long life and low
power consumption. It has applied latest software controlling technology
with effect such as 85 pictures, level and erecting moving, level and
erecting turning, enlarging and shrinking, gradually drawing, stroboscopic,
brightness regulation, etc. 26 different effects have been set inside. DMX
control has adopted page control (music control page, automatic control
page), the effect will be edited according to the actual music while without
music the light will be switched off after the delay. It has four control
modes: automatic control, DMX-512 control, music control and master&
slave synchronization control. The international standard DMX-512 signal
control makes the difference between our products and others.



Instruction：



After unpacking, please check whether the projector has been damaged
by transport such as screw loosening, reflecting mirror broken, etc.

Check before electrification. Check whether the projector has been laid
correctly and stably, whether the voltage of the power is adapted to the
requirement, otherwise we’ll not be responsible for the damage of the
light.

This projector is the first class protected equipment. Notice that while
using the green and yellow wires have to connect to the ground properly
by professionals. Please examine the electrics and voltage before
powering on it. We suggest customers apply 220V or a transformer. It’ll
check itself in seconds after being electrified, could be used.

3



Technical Parameters:

Rated voltage: AC110V /230V ±10%

Rated frequency: 50Hz〜60Hz±10％

Power consumption: 20W

Beads quantity: 192 super bright light pearls (red: 72pcs,
green: 72pcs, blue: 48pcs)

Pictures quantity: 85

Channels: 10 channels

Control signal: DMX-512 international standard signal

Control mode: DMX-512、automatic、music、master & slave

Operating environment: indoor



Function Mode Set:

This unit apply to Switch-address code, which is the choice of the mode of the
performing control and the address-code, the 10th address-code is the switch
of the transferring of the DMX-512 signal control , music control and automatic
control. The mode set, details as following:

Mode

Binary code（ON）

1

DMX-512signal control mode

1-9 setting address, 10--on

2

Single music control, master

1--ON、2-10--OFF

3

automatic ,master

9 ON, all others OFF

4

Slave control

1-9—NO SETTING、10--ON