STARVILLE LED TRI FLOOD Owner's Manual

Owner‘s Manual

15 x 15 W FLOOD LIGHT

LED TRI FLOOD

- 2 -

Thank you for choosing one of our LED TRI ood lights. Prior to use, we
suggest that you carefully read all of the instructions. By following the
suggestions found in this user manual, you can look forward to the reliable
and satisfactory performance of your LED light for years to come. Please
keep the manual for your future reference.

Safety Instructions

You must read and follow these safety instructions
prior to initial use!

• Do not power-up this device while it is still in the
packing. Do not connect it to the mains, before the installation is
nalized. Make sure the power is switched off before installation or
during maintenance.

• Keep children away from the power cord and the device. Children
frequently underestimate the dangers of electrical devices.

• To prevent accidental powering-up, always disconnect the device from
the mains, when it is not going to be used.

• Only connect the device to a properly wired and earthed mains
power socket providing the mains voltage stated in this manual.

• Do not operate the device if the power cord or the mains plug are
damaged.

• Do not place the unit in environments which contain high levels of dust,
heat, or vibration.

• Never submerse the device in water. Wipe it with a slightly moistened
cloth only. Never let any uid get into the housing.

• Make sure that the power cord never becomes wet or moist during use.

• Under no circumstances may you open the device housing. Should you
do so your safety would not be assured and the warranty will become
void. There are no operational components whatsoever inside, only
really high voltage that can give you a deadly shock!

• Notice regarding power disconnection
To completely disconnect the device from the mains power source the
power plug must be removed from the power socket. For this reason
the device must always be placed in a position where a constant
unobstructed access to the power socket is assured, thus in an
emergency situation you are able to immediately pull out the power
plug. To eliminate the risk of re you should completely disconnect the
power plug from the power socket when the device is not going to be
used.

- 3 -

• Always grasp the power cord by the plug. Do not pull on the cord itself
and never touch the power cord with wet hands as this could result in
a short circuit or an electrical shock. Do not place speaker cabinets or
anything else on the power cord and make sure that it does not become
clamped. Place the power cord in a position where it can not be trod on.
A damaged power cord can cause a re or an electrical shock. Check
the power cord from time to time. Should it become damaged contact
our customer service centre to have it replaced.

• Never leave the device unattended during operation.

• Never cover the ventilation slots of the device while it is on. Do not place
this unit in an enclosed environment such as a bookshelf or closet.
Ensure that there is adequate ventilation to cool the unit. Do not place
the device in locations that are subject to direct sunlight of strong articial
light. If you do, it may overheat and become irreparably damaged.

• Before a thunderstorm with a risk of lightning, please disconnect the
device from the electrical power source.

• Do not look at the LED light directly for long time, because that might
permanently damage your eyes.

Product Introduction

The LED TRI ood is a oodlight projector, which is revolutionary in the
history of stage lighting. It takes advantage of latticed LED illumination.
The optical light cup design adds more colors and a soft character to the
light beams. This is quite different from common integrated light beams
utilizing convergent lens. The latest liquid-crystal display makes it easy
and convenient to set light strength and color parameters. Our model
features a 30 degrees color blending lens and a constant ow driving
circuit.

The unit is suitable for use in places with stringent requirements such as
meetings, discos, bars, nightclubs, even gymnasiums and TV stages with
the IP 63 water-proof safety class.

Operation Instruction

After unpacking, please check whether the projector has been damaged
by transport such as screw loosening, broken housing, etc.

Check before electrication. Check whether the projector has been laid
correctly and stably, whether the mains power voltage is adapted to the
requirement, otherwise we’ll not be responsible for any damage to the
device.