VGA2VID
VGA to Composite/S-Video Converter
FCC Compliance Statement
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
Reorient or relocate the receiving antenna.•
Increase the separation between the equipment and receiver.•
Connect the equipment into an outlet on a circuit different from that to which the receiver •
is connected.
Consult the dealer or an experienced radio/TV technician for help.•
Use of Trademarks, Registered Trademarks, and other Protected Names and Symbols
This manual may make reference to trademarks, registered trademarks, and other protected
names and/or symbols of third-party companies not related in any way to StarTech.com. Where
they occur these references are for illustrative purposes only and do not represent an endorsement of a product or service by StarTech.com, or an endorsement of the product(s) to which
this manual applies by the third-party company in question. Regardless of any direct acknowledgement elsewhere in the body of this document, StarTech.com hereby acknowledges that all
trademarks, registered trademarks, service marks, and other protected names and/or symbols
contained in this manual and related documents are the property of their respective holders.
Instruction Manual
i
Instruction Manual
Table of Contents
Introduction ................................................................................... 1
Features ......................................................................................1
Package Contents .......................................................................1
Hardware Guide ............................................................................. 2
Front Panel ..................................................................................2
Rear Panel ...................................................................................2
Side Panel ...................................................................................3
Troubleshooting ............................................................................. 3
Technical Specifications ............................................................... 4
Technical Support ......................................................................... 5
Warranty Information .................................................................... 5
Instruction Manual
1
Introduction
Thank you for purchasing a StarTech.com High Resolution VGA to Composite or S-Video Converter. This simple hardware solution allows you to
convert a VGA/PC video signal into a Composite or S-Video signal for use
with a CRT or flat panel display.
The ideal solution for synchronizing monitors with television displays etc.,
the VGA2VID VGA to Composite/S-Video Converter offers selectable
NTSC or PAL format operating modes to ensure compatibility with virtually any configuration.
Features
Automatically detects and down-converts the incoming PC images to •
NTSC or PAL
Supports high resolution PC input up to UXGA (1600 x 1200 @ 60Hz)•
Scale down PC video to Composite/S-Video•
Switch between NTSC and PAL•
Image Overscan/Underscan selection•
Easy to install and simple to operate•
Easy to carry with palm size design•
Package Contents
1 x User manual•
1 x High Resolution VGA to Composite/S-Video Converter•
Instruction Manual
2
Hardware Guide
Front Panel
Power1. : Press to turn power On and Off.
PC input VGA connector2. .
DC power supply3. .
Rear Panel
S-Video ouput connector1.
Composite Video Output RCA connector2.
Underscan/Overscan:3. Switch the button to underscan/overscan the
picture
1 2 3
1
2 3
Instruction Manual
3
Side Panel
Troubleshooting
Problem Possible Causes Solutions
Power LED is not
illuminated
Power cord is not
connected correctly.
Ensure the power cord is
connected correctly
Power not available.
There may be a power
outage in your area.
Make sure that other
electronic devices are
working correctly.
On/Off LED is red
System may be in
standby mode.
Press the power button
on the VGA2VID
No Picture
A/V connection may
be loose.
Check that the A/V
cables are connected
securely
Incorrect TV source is
selected
Ensure that the correct
input source is selected
on the Composite/SVideo input. Refer to the
TV user manual for more
information.
Used to switch between NTSC or PAL system
Instruction Manual
4
Technical Specications
Input ports
PC
Output ports
Composite/S-video
Power Supply
5V DC
Dimensions
100(W) x 64(D) x 18.5(H)
Weight
100
Operating Temperature
Operating from 0°C ~ 70°C
Instruction Manual
5
Technical Support
StarTech.com’s lifetime technical support is an integral part of our commitment to provide industry-leading solutions. If you ever need help with your
product, visit www.startech.com/support and access our comprehensive
selection of online tools, documentation, and downloads.
Warranty Information
This product is backed by a one year warranty. In addition, StarTech.
com warrants its products against defects in materials and workmanship for the periods noted, following the initial date of purchase. During
this period, the products may be returned for repair, or replacement with
equivalent products at our discretion. The warranty covers parts and labor
costs only. StarTech.com does not warrant its products from defects or
damages arising from misuse, abuse, alteration, or normal wear and tear.
Limitation of Liability
In no event shall the liability of StarTech.com Ltd. and StarTech.com USA
LLP (or their officers, directors, employees or agents) for any damages
(whether direct or indirect, special, punitive, incidental, consequential, or
otherwise), loss of profits, loss of business, or any pecuniary loss, arising
out of or related to the use of the product exceed the actual price paid
for the product. Some states do not allow the exclusion or limitation of
incidental or consequential damages. If such laws apply, the limitations or
exclusions contained in this statement may not apply to you.
StarTech.com has been making “hard-to-find easy” since 1985,
providing high quality solutions to a diverse IT and A/V customer
base that spans many channels, including government, education
and industrial facilities to name just a few. We offer an unmatched
selection of computer parts, cables, A/V products, KVM and Server Management solutions, serving a worldwide market through our
locations in the United States, Canada, the United Kingdom and
Taiwan.
Visit www.startech.com today for complete information about all
our products and to access exclusive interactive tools such as the
Cable Finder, Parts Finder and the KVM Reference Guide.
Loading...