Page 1
4 Drive 2.5in Removable SAS SATA
Mobile Rack Backplane
SATSASBAY425
*actual product may vary from photos
DE: Bedienungsanleitung - de.startech.com
FR: Guide de l'utilisateur - fr.startech.com
ES: Guía del usuario - es.startech.com
IT: Guida per l'uso - it.startech.com
NL: Gebruiksaanwijzing - nl.startech.com
PT: Guia do usuário - pt.startech.com
For the most up-to-date information, please visit: www.startech.com
Manual Revision: 02/24/2012
Page 2
FCC Compliance Statement
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there
is no guarantee that interference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception, which can be determined by
turning the equipment o and on, the user is encouraged to try to correct the interference by
one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit dierent from that to which the receiver
is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Use of Trademarks, Registered Trademarks, and other Protected Names and Symbols
This manual may make reference to trademarks, registered trademarks, and other
protected names and/or symbols of third-party companies not related in any way to
StarTech.com. Where they occur these references are for illustrative purposes only and do not
represent an endorsement of a product or service by StarTech.com, or an endorsement of the
product(s) to which this manual applies by the third-party company in question. Regardless
of any direct acknowledgement elsewhere in the body of this document, StarTech.com hereby
acknowledges that all trademarks, registered trademarks, service marks, and other protected
names and/or symbols contained in this manual and related documents are the property of
their respective holders.
Instruction Manual
Page 3
Table of Contents
Introduction ............................................................................................1
Packaging Contents ................................................................................................................................. 1
System Requirements .............................................................................................................................. 1
Installation ..............................................................................................2
Software Installation ................................................................................................................................ 3
Conguration Diagram ........................................................................................................................... 4
Operation ................................................................................................5
Front Panel Pushbuttons ........................................................................................................................ 5
Keyboard Hotkeys ..................................................................................................................................... 5
KVM Switcher Software ........................................................................................................................... 6
Specications ..........................................................................................9
Technical Support ..................................................................................10
Warranty Information ............................................................................10
Instruction Manual
i
Page 4
Introduction
This StarTech.com SATSASBAY425 4-Drive Removable SAS/SATA Backplane/Mobile
Rack oers a convenient and ecient way to maximize the storage density of your PC
or Server. The backplane can hold up to four 2.5” SAS and/or SATA hard drives (9.5mm,
12.5mm, or 14.8mm thick) in a single 5.25in drive bay.
Packaging Contents
• 1 x SATSASBAY425 backplane
• 4 x Hard Drive Caddy (installed)
• 4 x SATA cable
• 1 x Screw kit
• 1 x Instruction Manual
System Requirements
• Available 5.25” external bay
• Existing SAS/SATA controller
Instruction Manual
1
Page 5
Front View
Power/Activity
Rear View
LED On/O switch
LP4 Power
connector
LED
Tray Release
Latch
7-pin SAS/SATA
connectors
Cooling Fans
Instruction Manual
2
Page 6
Installation
WARNING: Hard drives require careful handling, especially when being transported. If
you are not careful with your hard disk, lost data may result. Always handle your hard
drive and storage device with caution.
Hardware Installation
1. Turn your computer o and any peripherals connected to the computer (i.e. Printers,
external hard drives, etc.). Unplug the power cable from the rear of the power
supply on the back of the computer.
2. Remove the cover from the computer case. Refer to documentation for your
computer system for details.
3. Open an unused 5.25” external bay in the computer case.
4. Slide the SATSASBAY425 into the 5.25” bay, per the installation instructions for the
computer system/case and secure to the frame.
5. Connect an LP4 molex power connector from the computer power supply to the
power connector on the rear of the backplane.
6. Connect 7-pin SAS/SATA cables from the host SATA or SAS controller to each
connector on the rear of the backplane.
NOTE: SAS controller can operate both SAS and SATA drives, however SATA controllers
can only operate SATA drives.
7. Place the cover back onto the computer case.
8. Insert the power cable into the socket on the power supply and reconnect all other
connectors removed in Step 1.
9. Remove the drive trays from the backplane by pressing the colored tray release
latch to the left and swing it open. Pull the drive trays out of the backplane.
10. If using a 9.5mm height drive, then the top of the drive tray does not need to be
removed. Just slide the drive into the tray from the sides, then fasten the drive to
the tray from the bottom side with 4 screws (included).
If using a drive taller than 9.5mm, then the top of the drive tray needs to be
removed. Release the screw located near of the rear of the tray, then pull the top
of the tray o. Place the drive onto the tray and fasten from the bottom using 4
screws (included).
Driver Installation
No driver installation is required for any operating system, as a backplane is a passthrough device, so will not visible to the computer system.
Instruction Manual
3
Page 7
Specications
Bus Interface
Maximum Number of Hard Drives 4
Connectors
LEDs 4 x Power/Activity
Fan 2 x 40mm
Insertion Rating 25,000 cycles
Compatible Hard Drives
Operating Temperature -10°C to 70°C (14°F to 158°F)
Storage Temperature -20°C to 75°C (-4°F to 167°F)
Humidity 5~90% RH
Dimensions 175.0mm x 146.0mm x 42.0mm
Weight 790g
2.5” SATA, 9.5/12.5mm height
2.5” SAS, 14.8mm height
SATA
SAS
4 x 7-pin SATA/SAS
1 x LP4 Power
Instruction Manual
4
Page 8
Technical Support
StarTech.com’s lifetime technical support is an integral part of our commitment to
provide industry-leading solutions. If you ever need help with your product, visit
www.startech.com/support and access our comprehensive selection of online tools,
documentation, and downloads.
For the latest drivers/software, please visit www.startech.com/downloads
Warranty Information
This product is backed by a two year warranty.
In addition, StarTech.com warrants its products against defects in materials
and workmanship for the periods noted, following the initial date of purchase.
During this period, the products may be returned for repair, or replacement with
equivalent products at our discretion. The warranty covers parts and labor costs only.
StarTech.com does not warrant its products from defects or damages arising from
misuse, abuse, alteration, or normal wear and tear.
Limitation of Liability
In no event shall the liability of StarTech.com Ltd. and StarTech.com USA LLP (or their
ocers, directors, employees or agents) for any damages (whether direct or indirect,
special, punitive, incidental, consequential, or otherwise), loss of prots, loss of business,
or any pecuniary loss, arising out of or related to the use of the product exceed the
actual price paid for the product. Some states do not allow the exclusion or limitation
of incidental or consequential damages. If such laws apply, the limitations or exclusions
contained in this statement may not apply to you.
Instruction Manual
5
Page 9
Hard-to-nd made easy. At StarTech.com, that isn’t a slogan. It’s a promise.
StarTech.com is your one-stop source for every connectivity part you need. From
the latest technology to legacy products — and all the parts that bridge the old and
new — we can help you nd the parts that connect your solutions.
We make it easy to locate the parts, and we quickly deliver them wherever they need
to go. Just talk to one of our tech advisors or visit our website. You’ll be connected to
the products you need in no time.
Visit www.startech.com for complete information on all StarTech.com products and
to access exclusive resources and time-saving tools.
StarTech.com is an ISO 9001 Registered manufacturer of connectivity and technology
parts. StarTech.com was founded in 1985 and has operations in the United States,
Canada, the United Kingdom and Taiwan servicing a worldwide market.
Loading...